Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Press the VPS slightly inwards near its upper grip pawl. At the same time press the VPS
in the seat obtained between the outer and inner shells (Fig. 8).
Push the VPS upwards, making sure that the side slider is moving upwards (Fig. 7B).
Check the correct VPS operation by moving the left side slider downwards (Fig. 7A) and
upwards (Fig. 7B) until you hear the clicks meaning that it is in the relevant positions.
If necessary, repeat the above-mentioned steps.
-
If the visor and/or VPS opening/closing mechanisms are damaged or malfunctioning,
please contact a Nolan authorised dealer.
-
Do not use the helmet if the VPS has not been assembled properly.
WARNING
-
The VPS doesn't replace the protection guaranteed by the visor.
•
WIND PROTECTOR
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 10 for the assembly and disassembly.
•
REMOVABLE INNER COMFORT PADDING
1
DISASSEMBLY
1.1 Open the chin strap (see specific instructions), pull the front part of the left cheek pad
towards the inside of the helmet and pull out the left fastening chin strap from the slot
on the cheek pad (Fig. 11). Repeat the same operation on the right side of the helmet.
1.2 Release the roll-neck eyelet from the frame fixed to the outer shell (Fig. 12).
1.3 Release the left rear fastening flap from the support fixed to the inner shell by slightly
deforming the shell sealing edge and slightly pulling the comfort padding in the helmet
neck-ring area towards the inside (Fig. 13).
Then repeat the same steps to remove the central flap as well as the right rear flap.
1.4 Hold the left front part of the liner and pull it upwards in order to remove the liner flap
from the support fixed to the inner polystyrene shell (Fig. 14). Repeat the same steps
to remove the central and right front flap.
1.5 Completely remove the liner from the helmet.
2
ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base.
2.2 Insert the left front flap into the seat on the support fixed to the polystyrene inner shell
and push it slightly downwards until it is completely locked (Fig. 14). Follow the same
steps for the central and right front flap.
2.3 Insert the rear right, central and left flaps of the liner into the relevant support seats
in the helmet neck-ring area (Fig. 13). To perform this step, act as follows: slightly
deform the shell sealing edge and push the flaps until they are completely hooked
to the support.
2.4 Hook the roll-neck eyelet to the frame fixed to the outer shell (Fig. 12), making sure
that the frame central hole is free.
Note: Check the correct assembly of the liner front area by lifting and lowering the
VPS. These movements should be smooth. If this is not the case, repeat the steps
1.4 and 2.2.
15
Advertenties
Inhoudsopgave
