Advertenties
*If the tap water in your area is very hard, it is recommended that you mix the tap water with distilled
water. Otherwise, the steam cleaner could calcify prematurely and clog the steam nozzle.
*Please do not add water less than 150ml.
3. Close the safety cap anticlockwise.
4. Insert the mains plug into the socket, the red light will light up indicate heating.
As soon as the steam cleaner is operational, the green indicator light will on. The red indicator light
will on/off during usage.
Attention:
– Only use the product once the green indicator light
On at the first time. Otherwise, hot water that drips or sprays.
5. Turn the children lock to "on"position, then press the steam trigger. Steam will be released
directly. Remember you should always press the steam trigger. Once you released the steam
trigger, the children lock will turn back to "OFF" position auto and steam stopped.
Attention: Without pressing the children lock, there is no useful to steam trigger.
If there is no more water in the water tank, no more steam will be emitted when you push the steam
trigger .The water must be refilled as follows:
1. Pull the main plug out of the socket.
2. Push the steam trigger until no more steam is escaping.
3. Wait for cooling at least 12-18 minutes.
4. Slowly unscrew the safety cap and wait a few seconds
5. Slowly refill the water tank with water.
6. Close the safety cap again.
If the tap water in your area is very hard, it is recommended that you mix the tap water with distilled
water. Otherwise, the steam cleaner could calcify prematurely and clog the steam nozzle.
6.After usage, please turn the power off, release all the residual steam and wait for the machine
cooling down.
Advertenties
