Before Use; Assembly; Integration In A Vehicle - Ultimate Speed Smx-Ms31-01 Bedienings- En Veiligheidsinstructies
Ultrasone marterverjager met flitslicht
Inhoudsopgave
3. Before use
Assembly
The marten repellent can be assembled in a vehicle or set up or attached in a room.
The choice of the right installation location is a particularly important success factor
when using the product indoors: the ultrasonic waves and light rays should be able
to spread as far as possible to optimise the effectiveness of the marten repellent.
Integration in a vehicle
If your vehicle has already been infested with martens, carry out an engine
wash BEFORE installing the marten repellent. The marten repellent is not
splash-proof and must be removed before every subsequent engine wash.
Choose an installation location in the engine compartment that meets the
following requirements:
- The marten repellent is protected against water spray and dirt
- The marten repellent is not located directly beside the engine and is therefore
not exposed to excessive heat.
- The distance between the vehicle battery and the marten repellent is selected
to ensure that the vehicle battery cable 5 can be connected to the device
without touching moving or hot parts in the process.
Attach the marten repellent to your vehicle's engine compartment using the
cable ties provided. Depending on the type of power supply that you wish to
use, it may be advisable only to attach the device with two cable ties so that
the battery compartment F is still accessible at the back.
14 GB
Hoofdstukken
Inhoudsopgave
