Installation Or Assembly In A Carport, Garage, Attic Or Cellar; Power Supply; Inserting And Replacing Batteries - Ultimate Speed Smx-Ms31-01 Bedienings- En Veiligheidsinstructies
Ultrasone marterverjager met flitslicht
Inhoudsopgave
Installation or assembly in a carport, garage, attic or cellar
Choose an installation location for the marten repellent that meets the
following requirements:
- The marten repellent is protected against water spray (e.g. when used in a
carport) and weather conditions.
- The ultrasonic waves can spread easily in the chosen location
and the flashing lights are clearly visible.
- Recommended height: 80 to 100 cm above ground.
Attach the marten repellent (if required) using the cable ties provided or
using screws (not included in the scope of delivery).
Depending on the type of power supply required, please bear in mind that
the battery compartment must remain F accessible at the back.
Power supply
The ultrasonic marten repellent with flashing light can be supplied with electricity in
three different ways: batteries, the vehicle battery or a USB power supply.
Inserting and replacing batteries
Open the battery compartment F using a small Phillips screwdriver (not
included in the scope of delivery)
Insert four AA LR6, 1.5 V batteries 2 in the battery compartment. Make
sure that you observe the correct polarity, which is indicated in the battery
compartment and on the batteries.
Close and screw down the battery compartment with a Phillips screwdriver.
15
GB
Hoofdstukken
Inhoudsopgave
