Replacing The Fuse - Ultimate Speed Smx-Ms31-01 Bedienings- En Veiligheidsinstructies
Ultrasone marterverjager met flitslicht
Inhoudsopgave
Vibration sensor: The ultrasonic marten repellent switches to stand-by mode
if movements and vibrations are detected, e.g. when the vehicle's engine is
switched on, and starts the next operating cycle approx. 120 seconds after the
last movement or vibration. The indicator light lights up B
approx. every five seconds in stand-by operation.
Press the on / off switch A on the marten repellent to position "o" to switch the
device off.
Remove the batteries from the device or disconnect it from the power supply if it is
not being used for a long time.
Replacing the fuse
A 5 x 20 mm F500MAL250V glass fuse 5 can be found in the vehicle battery
cable P . If the marten repellent cannot be switched on when the vehicle battery is
properly connected, it may be because the glass fuse has blown.
Proceed as follows to replace the fuse P :
18 GB
Hoofdstukken
Inhoudsopgave
