Use Instructions; Starting The Appliance; Shutting Down The Appliance - Kemper Smart 104987Ss Handleiding Voor Installatie, Gebruik En Onderhoud
Inhoudsopgave
Beschikbare talen
Beschikbare talen
containers.
2.
All operations of assembly and change of cartridges must be done in a well-ventilated place and far from
flames and inflammable materials.
3.
Never smoke while handling cartridges.
4.
Read carefully the instructions on the wrapping of the cartridge before using.
5.
Remove the cartridge after each use in order to avoid overheating the appliance.
6.
Never expose cartridges at temperatures over 50°C.
7.
Always keep the appliance away from children
8.
Never try to refill a disposable cartridge.
9.
Never breathe in the gas coming from the cartridge or the smoke produced while using the appliance.
10. When the appliance is not used, the cartridge must be disengaged by positioning the cartridge connection
lever D on "UNLOCK".
IN CASE OF LEAKAGE (SMELL OF GAS) BRING YOUR APPLIANCE IMMEDIATELY OUTDOORS, IN A
VENTILATED PLACE WITH NO INFLAMABLE SOURCES, AND THEN YOU CAN LOOK FOR LEAK AND
STOP IT. IF YOU WANT TO CHECK THE SEAL OF YOUR APPLIANCE, DO IT OUTDOORS AND NEVER
LOOK FOR A LEAKAGE WITH A FLAME BUT USE SOAPSUDS.
BEFORE USING CHECK THAT THERE ARE NO LEAKS. Check the leakage of your device only outside. Do
not seek the leakage with a match but use water and soap or a gas detector (our article Revelgas cod. 1726).
Apply solution of soap and water or gas detector in the interspaces of the unit. If bubbles appear, it means that
there is a leak and it must be repaired before use. If you detect a leak and you cannot repair it, do not try to fix
it another way, but contact the customer service. Do not use a device that leakage, deteriorated or
malfunctioning.
STARTING THE APPLIANCE
1.
Do not use the hot plate other purposes than cooking.
2.
Put the hot plate on a stable and horizontal surface. Do not alongside two or more burners.
3.
Put the hot plate far from inflammables substances or things that can be damaged by heat.
4.
Make sure that in the hot plate, the lever connecting the cartridge is in "UNLOCK" position and the gas valve
knob is in "OFF" position.
5.
Make sure that the seals are in a good state before connecting the gas
cartridge.
6.
Never use the appliance with damaged or worn seals.
7.
Never use the appliance if it leaks, is deteriorated or malfunctioning.
8.
Put the cartridge in its slot, placing the cut on its neck in correspondence to
the safety stop.
9.
Place the lever connecting the cartridge on the "FUEL LOCK" position.
WARNING: the appliance is now ready for use. The positioning of the
lever on "FUEL LOCK" presupposes the immediate ignition of the
stove as the gas circuit is ready for gas supply. Do not leave the
appliance unattended and without flame with the lever positioned on
"FUEL LOCK".
WARNING: the openings at the base of the burner provide air for
combustion, they should never be obstructed.
WARNING: Closed the cartridge cover before lighting. Not closing the cover
can cause the cartridge to overheat.
10. Push and turn anticlockwise all the way the cock until it is positioned on "IGNITION" where the piezo ignition
will ignite the flame.
11. If the stove dose not light, turn the control knob back to "OFF" position and repeat.
12. If after three failed attempts, the stove dose not light, turn the control knob to the "OFF position and move
the cartridge lever to the "UNLOCK" position.
13. Open the cartridge cover and remove the cartridge, Shake the cartridge to see if it is empty. If empty, replace
the cartridge and repeat from point 9.
14. Regulate the flame according to your needs.
15. Warning: The appliance does not have a flame supervision device. Do not leave the appliance unattended
during use.
SHUTTING DOWN THE APPLIANCE
1.
To turn off the appliance, rotate clockwise the cock to the "OFF" position and wait until the flame is fully
extinguished before performing the next step.
2.
Position the cartridge-connecting lever on the "UNLOCK" position and remove the gas cartridge from the
compartment.
3.
Wait for the plate to cool before storing it.
4.
When the appliance is not in use, it is mandatory to remove cartridge out of the appliance.
5.
This unit can be kept inside only if the cartridge has been disconnected and removed from the appliance. If
DT Istr 104987SS_02/2020_REV.6_10/24
LEAKAGE TEST
USE INSTRUCTIONS
104987SS
13/76
Inhoudsopgave
