Replacing The Lamp; Troubleshooting - Aeg Ndv656Hb Gebruiksaanwijzing
Inhoudsopgave
Refer to the leaflet provided with the
filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Press the front edge in slot towards the
bottom part of the filter. Slightly tilt the
front of the filter downwards.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
The appliance does not absorb
enough vapours.
The filter alarm indicator
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
The lamp is defective.
The motor speed is not adequate to
the appearing vapours.
The filter alarm is on. The grease fil‐
is on.
ter must be cleaned or the charcoal
filter (optional) must be replaced or
cleaned.
3. To install a new filter, perform the same
steps in reverse order.
In any case, it is necessary to replace the
filters at least every four months.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp. Refer to the
"Care and Cleaning" chapter.
Change the speed of the motor.
Refer to the filter notification in "Dai‐
ly use" chapter.
65
Hoofdstukken
Inhoudsopgave
Probleemoplossen
