Hama 00221058 Gebruiksaanwijzing pagina 8
Note
• If no button is pressed for 30 seconds during the learning
process or no signal is received, the LED flashes 6 times
and the learning process is automatically cancelled
without saving.
• Buttons that have been taught the new function transmit
it via infrared and no longer via Bluetooth.
• With the exception of the Voice Assistant button, all
buttons can be assigned a new function.
7. Low charge indicator
If the charge level of the internal energy storage is too low,
the LED flashes 6 times each time the button is pressed. In
this case, place the remote control in a bright, well-lit place to
charge it via the solar panel. Alternatively, you can charge the
remote control using a suitable USB-C charger.
8. Meaning of LED displays
Unless otherwise stated in the other chapters, the LED displays
the following information:
• Each time the button is pressed, the LED lights up red.
• While the setting mode is activated, the LED lights up red
continuously, even if no button is pressed. If the input time
is exceeded, the LED goes out.
• While the remote control is charging via USB-C, the LED
flashes green.
• When the replacement remote control is fully charged, the
LED lights up green continuously until the remote control is
disconnected from the charger.
9. Restoring factory settings
• Press and hold the "Home (14)
a USB power supply at the same time. As soon as the LED
lights up red, you can release the button. The LED goes out.
The remote control is now reset to the factory settings.
Note
• All Bluetooth connections, settings made, buttons
memorised or copied and all settings are deleted.
" button and connect
10. Maintenance
• Never use old and new batteries in the universal remote
control at the same time, as old batteries tend to leak and
can lead to a loss of performance.
• Never clean the universal remote control with scouring
agents or harsh cleaning agents.
• Keep the universal remote control free of dust by cleaning it
with a dry soft cloth.
11. Troubleshooting
F: My replacement remote control does not work!
A: Check the charge status of the remote control. If necessary,
connect it briefly to a USB power supply.
A: Check your TV set. If the main switch is switched off, the
replacement remote control cannot operate the TV.
12. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
13. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00221058] is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address:
https://support.hama.com/00221058
Frequency band(s)
Maximum radio-frequency power
transmitted
14. Specifications according to Regulation (EU)
2023/826
Information regarding energy consumption can be found at:
https://support.hama.com/00221058
2402 – 2480 MHz
2,5mW E.I.R.P.
7
