Initial Operation; Proper Use; Remaining Hazards - Scheppach Bgs 700 Handleiding
Verberg thumbnails
Zie ook voor bgs 700:
- Vertaling van de originele handleiding (152 pagina's) ,
- Vertaling van de originele handleiding (61 pagina's)
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Initial Operation
points:
ing wheel has reached its operational speed before start-
ing to work.
from one side to the other slowly and constantly on the
grinding wheel.
the work piece until the wheel regain their speed.
Important note:
similar tool.
be careful with the work piece.
Changing the grinding wheels
WARNING: In order to avoid injury caused by inadvert-
ently starting the machine, the appliance must always be
out of the socket, before changing the grinding disc.
far as possible. Do not remove these parts!
assmeble the new one.
Important note:
the wheel, as they are intended for strengthening the
grip of the Flange against the grinding wheels.
ible damages and dispose if necessary.
grinding wheel to break.
to installation instructions.
Changing the abrasive belt
with the belt pulley and remove the abrasive belt side-
ways.
belt pulley, impose the new abrasive belt on the rollers
(when doing this be careful of the direction of the belt
amd screw on the set screw once more.
To ensure a dead-centre positioning, rotate the abrasive
belt by hand. When using, adjust with the adjusting grip
Turn the machine off briefly, test the running of the belt
once more and if necessary readjust.
8 english
All manuals and user guides at all-guides.com
-
-
Proper Use
rective.
instructions as well as the technical data given in the
calibrations and dimensions must be adhered to.
erally recognized safety and technical rules must also be
adhered to.
by trained persons who are familiar with the machine
and have been informed about the dangers. Unauthor-
cations.
parts and original tools from the producer.
manufacturer excludes any liability for resulting dam-
ages, the risk is exclusively borne by the user.
Remaining hazards
The machine has been built using modern technology and
in accordance with recognized safety rules.
Some hazards, however, may still remain.
improperly feeding or running the tool to be grinded
ing or feeding.
to elctrical injuries.
may still remain not obvious remaining hazrds.
the entire operating manual.
-
-
-
-
-
Inhoudsopgave
