Scheppach HC06 Vertaling Van De Originele Gebruiksaanwijzing pagina 27
Verberg thumbnails
Zie ook voor HC06:
- Vertaling van de originele gebruikershandleiding (96 pagina's)
Beschikbare talen
Beschikbare talen
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Sound power level L
wA
Sound pressure level L
pA
Uncertainty K
wA/pA
7.
Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the device by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and spare
parts use only original parts. Spare parts can be ob-
tained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m WARNING!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
8. Before commissioning
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
• Check the device for transport damage. Report
any damage immediately to the transport company
which was used to deliver the compressor.
• Install the compressor near the point of consump-
tion.
• Avoid long air lines and supply lines (extension ca-
bles).
• Make sure that the intake air is dry and free of dust.
• Do not deploy the compressor in damp or wet areas.
• Operate the compressor only in suitable areas (well
ventilated, ambient temperature +5°C to 40°C).
There must be no dust, acids, vapours, explosive
gases or inflammable gases in the room.
• The compressor is designed to be used in dry
97 dB
rooms. It is prohibited to use the compressor in ar-
75.5 dB
eas where work is conducted with sprayed water.
0.35 / 3 dB
• The compressor may only be used outdoor briefly
when the ambient conditions are dry.
• The compressor must always be kept dry and must
not be left outdoors after work is complete.
9.
Operation
m Attention!
Always make sure the product is fully assembled
before commissioning!
9.1 Mains power connection
• The compressor is equipped with a mains cable with
protective contact plug. This can be connected to
any 220 ‒ 240 V~ 50 Hz protective contact socket,
with fuse protection of at least 16 A.
• Before commissioning, ensure that the mains volt-
age matches with the operating voltage and the ma-
chine's power rating on the type plate.
• Long supply cables, extensions, cable reels, etc.
cause a drop in voltage and can impede motor
start-up.
• In the case of temperatures below +5°C, motor
starting can be endangered by sluggishness.
9.2 ON/OFF switch (Fig. 1)
• The compressor is switched on by setting the switch
(2) to position I.
• The compressor is switched off by setting the switch
(2) to position 0.
9.3 Pressure adjustment: (Fig. 1)
• The pressure at the manometer (5) can be adjusted
with the pressure regulator (3).
• The pressure set can be utilised by connecting to
the quick-coupling (6).
9.4 Pressure switch adjustment
• The pressure switch is set in the factory.
Switch-on pressure ca. 6 bar
Switch-off pressure ca. 8 bar
www.scheppach.com
GB | 27
