THOMSON TDW4510WH2 Handleiding pagina 106
Beschikbare talen
Beschikbare talen
phase than hand dishwashing when the household dishwasher is used according to the
manufacturer's instructions.
The values given for programmes other than the eco programme are indicative only.
STARTING A WASH CYCLE
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
Ensure that they are clean and properly positioned. See the section Cleaning and Maintenance.
4. Check that there is rinse aid and salt.
5. Load the dishes.
Ensure that the spray arm can rotate freely.
6. Add the required amount of detergent into the dispenser according to the Washing Program chart.
7. Close the dishwasher door securely.
8. Press
to switch on the dishwasher.
9. Repeatedy press
The corresponding programme indicator light will illuminate.
Delay Timer: The delay timer allows you to delay the start of a washing program from 1 hour up
to 24 hours.
Repeatedly press
e.g. H:03 for a 3-hour delay.
Once the delay timer has been set, press
To cancel the delayed start, first press
"H:00".
10. If you want to perform a half load wash, press
illuminate.
When you have about or less than 5 place setting dishware to wash, you can choose this function
to save energy and water.
This function can only be used with ECO, Hygiene, Glass and 90 min.
11. If you want to activate other functions, repeatedly press
illuminates.
The extra drying function
programmes. When this function is activated, the dishwasher will increase temperature at the end
of a washing programme to improve drying.
The power wash function
programmes. When this function is activated, the dishwasher will increase temperature during
main wash. Choose this function for better cleaning performance and energy and water
consumption will be increased.
/
to select the desired washing program.
until the desired delayed start time is shown on the display,
and then repeatedly press
can only be used with the ECO, Hygiene, Glass and 90 min
can only be used with the ECO, Hygiene, Glass and 90 min
EN-17
to activate the function.
and the corresponding indicator light will
until the desired function indicator light
until the display shows
