Bestway 58773 Gebruikershandleiding pagina 3
Chlorinator
Inhoudsopgave
Beschikbare talen
Beschikbare talen
SETUP
CHECK LIST
To check the parts list inside the manual. Verify that the equipment components represent the model that you had intended
to purchase. In case of any damaged or missing parts at the time of purchase, visit our website bestwaycorp.com/support.
Drawings are for illustration purposes only. May not reflect actual product. Not to scale.
PRODUCT SPECIFICATIONS
Maximum chlorine production per hour:
Sand filter/Filter pump flow range:
Salt concentration:
Water temperature:
Ambient temperature:
Compatible with max water capacity:
RECOMMENDATIONS BEFORE INSTALLATION
• The chlorinator must be installed at the last position of the water circulation pipe (down the direction of the water flow) as
shown in "1".
• Only use sodium chloride (NaCl) salt with a purity of at least 99.8% to fully dissolve it.
• Too low salt purity will reduce the efficiency of the chlorinator and result in low chlorine production. High salt purity may
produce a salty taste to the pool water and it may cause corrosion to metal fixtures and fittings in the pool.
• The "Pool Salt Table" shows the correct amount of salt required. Refer to the different quantity of water. The salt in the
pool will not automatically decrease. Only when the pool water is lost will the salt in the water decrease, and the
evaporation of water will not cause the salt to decrease.
• The product comes with a pre-installed part on the water outlet port, which should be removed for ideal performance
when using a filter pump/sand filter with a flow rate of 800 gal or more. Keep the part for future use.
Pool capacity
(gal)
500
750
1000
1250
1500
1750
2000
2200
If the device shows error E2, it is necessary to reduce the salt concentration: Drain about 20% of the pool water, and then
refill with clean water. Wait 1 hour, and if the error still remains, repeat the operation until the E2 error disappears.
In case the quantity of water of your pool is not listed in the "pool salt table", follow the below formula to calculate the correct
quantity of salt to add to the pool to reach the 3000 ppm of salt concentration, or in case the E1 error appears on the display.
The amount of salt added for the first time:
(lb)
Water capacity (gal)
*0.025
2 g/h
330-1000 gal/h
3000 ppm (3 g/L)
10ºC (50ºF) - 40ºC (104ºF)
5ºC (41ºF) - 45°C (113ºF)
2200gal (8327L)
The amount of salt added for the
first time 3.0 g/L (3000 ppm)
(l)
(lb)
1893
13
2839
19
3785
25
4731
31
5678
38
6624
44
7570
50
8327
55
(kg)
Water capacity (l)
*0.003
Pool Salt Table
(kg)
6
9
11
14
17
20
23
25
The amount of salt that needs to be
added if the "E1" error code displays:
(lb)
Water capacity (gal)
*0.0084
3
Display code "E1" the amount of
salt that needs to be added
(lb)
4
6
8
10
12
15
17
18
(kg)
Water capacity (l)
*0.001
(kg)
2
3
4
5
6
7
8
8
Inhoudsopgave
