Switching On The Product - Beaba Milkeo Plus Handleiding
Inhoudsopgave
Beschikbare talen
Beschikbare talen
4. Switching on the product
2
- Pour the water into the water reservoir
1
- Pour the powder into the powder reservoir
- Plug in the product
- Press the power button.
3
- When using for the first time, remove the powder reservoir, place an empty bowl on bottle stand, start the pre-clean cycle by
pressing the
button. At the end of the cycle put on the powder reservoir.
- If you do not use the product for a period of 3 minutes, the control panel locks automatically. To unlock it, press the lock/
unlock button for 1,5 seconds
- You can lock the control panel manually by pressing the lock/unlock button for 1,5 seconds
5. Configuration for the first bottle
When using for the first time, it is necessary to configure the product. For this, it is necessary to:
- Press once on the settings button
- The temperature icon flashes
Set the desired temperature with the + and – buttons
- Press again on
, the water quantity icon flashes
and define the quantity of water required.
- Press again on
, the powder type icon flashes
and define the quantity of powder required. For information about
the quantity of power, follow the indications in the next section.
- Press the settings button
to confirm
4
- Place the bottle on the bottle stand
selecting one of the two heights according to the size of the bottle
- Press the bottle preparation button
to prepare a bottle.
The settings will be saved for the following bottles. Repeat the operation to change the settings. If you modify the quantity
of water, the quantity of powder is adjusted automatically to keep the same ratio.
15
Inhoudsopgave
