Stihl FSA 130 Handleiding pagina 41
Beschikbare talen
Beschikbare talen
18 Troubleshooting
18 Troubleshooting
18.1
Troubleshooting the Brushcutter and Battery
Fault
LEDs on the
battery
The brushcutter
1 LED flashing
does not start
green.
when switched
on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs fla‐
shing red.
The brushcutter
3 LEDs light
cuts out during
up red.
operation.
The runtime of
the brushcutter is
too short.
19 Specifications
19.1
STIHL FSA 130 Trimmer
Approved batteries:
0458-726-9621-C
All manuals and user guides at all-guides.com
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
The brushcutter has a
malfunction.
The brushcutter is too
hot.
There is a fault in the
battery.
No electrical contact
between brushcutter
and battery.
The brushcutter or
battery is damp.
The brushcutter is too
hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery life has
been exceeded.
Remedy
► Recharge the battery fully as described
in the User Manual for the STIHL AL
101, 300, 500 chargers.
► Pull the connecting cable plug out of the
socket.
► Allow the battery to cool down or warm
up.
► Pull connecting cable plug out of the
socket and plug in again.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use your brushcutter and contact your
STIHL dealer for assistance.
► Pull the connecting cable plug out of the
socket.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the
socket and plug in again.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
► Pull connecting cable plug out of the
socket and plug in again.
► If the brushcutter still does not start
when switched on: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Allow the brushcutter or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the
socket and plug in again.
► If the brushcutter continues to cut out
during operation: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Switch on the brushcutter.
► Recharge the battery fully as described
in the User Manual for the STIHL AL
101, 300, 500 chargers.
► Replace battery.
– STIHL AR
– STIHL AP together with "AP belt bag with
connecting cable"
English
41
