Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.1.3 Installing the battery
1. Put the battery back in the battery holder.
Installing the battery
2. Now turn the key clockwise and remove it. The battery
is now locked in place.
Locking the battery
3. Make sure the battery is firmly in place.
6.2
Battery information system
There is a battery information system with four LEDs and a
battery button on the top of the battery. The LEDs light up
as soon as you press the battery key. The charge state and
capacity of the battery is indicated by the number of LEDs
that light up and the way in which they light up.
Battery button
6.2.1 Checking the charge state
Press the battery button briefly. The LEDs light up and
display the current battery charge state.
16
Original User Manual | Groove 2.0
DISPLAY
••••
4 LEDs light up
•••
3 LEDs light up
2 LEDs light up
••
•
1 LED lights up
* If the battery is empty, it will work again briefly follow-
ing a short period of rejuvenation and will then switch
back off. It must now be charged.
Check the battery charge level before every trip to
make sure it is sufficient for the planned journey.
6.3
Battery management
The battery management monitors the temperature of
your battery and warns you of incorrect use.
If an external short-circuit has been caused at the
contacts or the charging socket, please consult
your specialist cycle shop.
Never leave the battery unattended during charg-
ing. Disconnect the charger after use.
6.4
Warranty and service life
Batteries are wear parts. Wear parts come with a two-year
warranty.
If a fault occurs during this period, your specialist cycle
shop will replace the battery. Normal ageing and battery
wear do not constitute a fault.
The service life of the battery depends on different factors.
The most important wear-relevant factors are:
BATTERY CHARGE
STATE
100 – 75%
75 – 50%
50 – 25%
25 – 0%*
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
