Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
F.2
Setting the temperature
• Touch Program button for 3 seconds to unlock the display;
• Press the temperature button.
The display shows the SET POINT.
• Press the UP arrow
change the SET value,
• Touch Program button to confirm the change.
If no button is pressed for 20 seconds (TIME OUT), the digital
thermostat memorises the last set value and the normal
display is restored.
The temperature range is set from a minimum to a maximum,
according to the following values:
Min. setting =
Max. setting =
Min. setting =
Max. setting =
F.3
Signalling icons
lit up
This icon indicates compressor
activation.
lit up
This icon indicates defrost function in
progress.
lit up
This icon indicates activation of com-
partment fans.
lit up
This icon indicates that a alarm has
occurred during appliance operation.
G
MACHINE CLEANING AND MAINTENANCE
WARNING
Refer to "Warning and Safety
Information".
G.1
Ordinary maintenance
G.1.1
Care information
Care operations have to be carried out by the owner and/or
user of the appliance.
or the DOWN arrow
- 22℃
- 15℃
- 2℃
+ 10℃
F.4
Alarms and signalling
The alarm is signalled by lighting up of the Icon
Alarm signalling is also indicated by the alarm code appearing
on the display (see section H.2 Troubleshooting).
Example: Alarm signalling due to a faulty probe (compartment
probe) appears directly on the instrument display with the
message E0 and rE flashing alternately.
Press any button to mute the buzzer.
When the alarm condition ceases, the alarm goes off.
Otherwise, contact the Customer Care Service.
F.5
Defrost
Automatic defrost
The appliance has an automatic defrost function. This function
is signalled by lighting up of the icon
run into a tray and automatically evaporated.
Manual activation of defrost
• Touch Program button for 3 seconds to unlock the display;
to
• Press defrost button
Defrost can be stopped manually at any time by pressing again
the button
; the display shows the message dFE. Defrost
cannot be activated in the programming stage.
F.6
Product loading
Distribute the product evenly inside the compartment (away
from the door and back) in order to allow good air circulation.
WARNING
Cover or wrap food before plac-
ing it in the refrigerator and avoid
putting very hot foods or steam-
ing liquids inside.
Do not leave the door open any longer than necessary when
loading or removing food.
It is advisable to keep the keys (for models with lock) in a place
only accessible to authorised personnel.
To prevent unauthorised personnel from opening the appli-
ance, it is advisable to always close it with the key.
IMPORTANT
Problems resulting from poor or lack of care as
hereinafter described will not be covered by the
warranty.
G.1.2
Cleaning introduction
For detailed information regarding appliance cleaning refer to
paragraph A.11 Cleaning the cabinet and accessories.
G.1.3
Periods of non-use
If the appliance is not going to be used for some time, take the
following precautions:
• disconnect the power supply or remove the plug from the
power socket, if present;
11
.
. The defrost water is
to start a manual defrost cycle.
Advertenties
Hoofdstukken
Inhoudsopgave
