Preparing The Unit Fixings; Preparing The Unit (Rtx1000/2000 Only); Attaching The Seal For The Cab Roof - Dometic Coolair Rtx1000 Montagehandleiding
Montageset voor universele inbouw 1 (bevestiging met openingsysteem)
Verberg thumbnails
Zie ook voor CoolAir RTX1000:
- Gebruiksaanwijzing (344 pagina's) ,
- Montagehandleiding (208 pagina's) ,
- Montagehandleiding (200 pagina's)
Inhoudsopgave
Beschikbare talen
Beschikbare talen
CoolAir
7.3
Preparing the unit fixings
➤ If necessary:
Drill out the 8 factory-made holes to a diameter of 8.5 mm (fig. 7).
7.4
Preparing the unit (RTX1000/2000 only)
A
NOTICE! Damage hazard
When preparing the unit on the work surface, make sure it is secured against
falling off.
Make sure that the work surface is clean and level to ensure that the unit is not
damaged.
Proceed as follows (fig. 8):
➤ Place the parking cooler on a work surface with the casing facing down.
➤ Screw the 8 self-tapping M8 threaded plugs into the blind holes marked "1".
To do so, use the 1/4" bit supplied.
➤ Screw the 4 self-tapping M6 threaded plugs into the blind holes marked "7".
Use a 5 mm hexagon bit to do so.
7.5
Attaching the seal for the cab roof
A
NOTICE! Damage hazard
Ensure that the surface where the seal between the unit and the cab roof is to
be glued is clean (free of dust, oil, etc.).
➤ Glue the sealing strip to the cab roof (fig. 9 A).
Follow the contour of the roof hatch opening. The join between the ends of
the seal should be at the back.
– 10 x 20 mm for the most common installation situations
– 35 x 20 mm if more space is required between unit and cab roof
➤ Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710) to the
join between the ends of the sealing strip and to the top edge of the sealing
strip (fig. 9 B).
EN
Installation
11
Hoofdstukken
Inhoudsopgave
