Before First Use; Operation; Switching The Jump Starter On; Switching The Lcd Display On - Dometic Pjs1000 Gebruiksaanwijzing
Starthulp met powerbank
Inhoudsopgave
Beschikbare talen
Beschikbare talen
PJS1000
8 Before first use
➤ Charge the jump starter before first use or after long storage until it is fully charged (see chapter "Charging the
jump starter" on page 15).
9 Operation
9.1 Switching the jump starter on
➤ Press the
button to switch the jump starter on.
✔ The LCD display switches on.
✔ The device is ready for use.
9.2 Switching the LCD display on
I
NOTE
The LCD display automatically switches to the power saving mode after 20 seconds if
no settings are made.
➤ When the LCD display is in power saving mode, press the
✔ The LCD display switches on.
9.3 Switching the jump starter off
I
NOTE
• The jump starter automatically switches off after 20 seconds if no load and no
charging source are connected.
• The jump starter cannot be switched off when a load or charging source is
connected.
1. If connected, disconnect the loads or the charging source.
2. Press and hold the
✔ The LCD display switches off.
✔ The device is switched off.
9.4 Charging the jump starter
I
NOTE
When the device is discharged, a full charge takes 3 – 5 hours with either charging
method.
The jump starter can be charged in two methods:
• Using the car charger (fig. 4 A, page 5).
• Using the mains charger (fig. 4 B, page 5).
➤ Place the jump starter on a firm base.
➤ To charge the jump starter proceed as shown (fig. 4, page 5).
EN
button for at least 5 seconds.
button briefly.
Before first use
15
Hoofdstukken
Inhoudsopgave
Probleemoplossen
