Dometic PJS1000 Gebruiksaanwijzing pagina 17
Starthulp met powerbank
Inhoudsopgave
Beschikbare talen
Beschikbare talen
PJS1000
I
NOTE
• The jump starter can jump-start up to 30 times, depending on the displacement and
vehicle engine.
• Jump-starting may not work properly for vehicles that require remote battery jumper
locations (e.g., battery is in the trunk or other location). Refer to the operating man-
ual of your vehicle.
Battery clamps' LED signal
Flashes green and red
Continuously lit red, with beeping alarm tone
Continuously lit green for 30 seconds, then changes
to continuously lit red
Continuously lit red, with low constant tone
Observe the following instructions before jump-starting vehicles:
• Put the vehicle in parking position. Ensure that vehicles with manual transmission are in neutral and the hand-
brake is engaged.
• Ensure that the jump starter is at least 50 % charged. If the state of charge is below 50 %, the jump starter may
not be able to jump start a vehicle.
• Ensure that the plug (EC5) is firmly seated in the jump-starting output on the jump starter.
• Disconnect all digital mobile devices before connecting the battery clamps.
Observe the following instructions after jump-starting vehicles:
• Disconnect the battery clamps within 30 seconds in reverse order (see chapter "Disconnecting the battery
clamps (fig. 7, page 7)" on page 18).
• Switch on electrical consumers, e.g., ventilation to protect the on-board electronics.
• Keep the engine running or drive the vehicle for at least 30 minutes to ensure that the battery can sufficiently
recharge.
Connecting the battery clamps (fig. 6, page 6)
1. Connect the red (rd) battery clamp to the positive terminal of the starting battery.
2. Connect the black (bk) battery clamp to ground (chassis).
I
NOTE
• If specified, observe the information on suitable ground points in the operating
manual of the vehicle.
• Suitable ground points are stable unpainted metal parts in the engine compart-
ment, e.g., the engine block.
• If you cannot connect the black battery clamp ground (chassis), connect it to the
negative battery terminal.
✔ The red and green LED of the battery clamps flash 1 – 3 seconds. Afterwards the green LED of the battery clamp
lights up continuously.
EN
Description
The jump starter is ready for connection.
The battery clamps are connected in reverse polarity.
Disconnect the battery clamps and reconnect them to
reuse. The LED will be continuously lit green again.
The battery clamps are in contact to each other.
Operation
17
Hoofdstukken
Inhoudsopgave
Probleemoplossen
