Cleaning And Maintenance; Troubleshooting - Dometic Pjs1000 Gebruiksaanwijzing
Starthulp met powerbank
Inhoudsopgave
Beschikbare talen
Beschikbare talen
PJS1000
10 Cleaning and maintenance
!
WARNING! Electrocution hazard
Unplug the device from the power supply before each cleaning and maintenance.
A
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach during clean-
ing as these can damage the device.
➤ Occasionally clean the device with a soft, damp cloth.
➤ Regularly check live cables or lines for insulation faults, breaks or loose connections.
➤ Regularly check the state of charge of the device battery. Charge the battery after each use and at least every
3 – 6 months, even when not in use.
11 Troubleshooting
Fault
The jump starter does not
work. The
button
does not work.
The vehicle is not jump-
started.
The red LED of the battery
clamps lights up.
EN
Possible cause
The jump starter is deeply
discharged.
Insulation faults, breaks or
loose connections at the
live cables.
The low voltage protection
of the jump starter is
active.
The over current protec-
tion of the jump starter is
active.
The short circuit protection
of the jump starter is
active.
The battery is significantly
sulfated.
The jump starter is less
than 50 % charged.
The battery clamps are
loose or not connected
correctly.
The battery terminals are
dirty or corroded.
The jump starter voltage is
too low.
Suggested remedy
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Check live cables for insulation faults, breaks or
loose connections.
➤ If you cannot find an error, contact an authorized
service agent.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Remove the load from the USB or 12 V DC output.
Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Remove the load from the USB or 12 V DC output.
Charge the jump starter (see chapter "Charging
the jump starter" on page 15) to reactivate it.
➤ Replace the battery.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Check the connections. Ensure that the battery
clamps are firmly secured and connected cor-
rectly. Reconnect if necessary.
➤ Clean the battery terminals and reconnect the
jump starter.
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
Cleaning and maintenance
19
Hoofdstukken
Inhoudsopgave
Probleemoplossen
