Warranty - Dometic Pjs1000 Gebruiksaanwijzing
Starthulp met powerbank
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Warranty
Fault
The red LED of the battery
clamps lights up and a
buzzing sounds.
The green LED of the bat-
tery clamps lights up and
the red LED flashes.
The red LED of the battery
clamps flashes. The jump
starter does not operate.
The jump starterdoes not
operate after it is
connected to the starting
battery.
The red and green LED of
the battery clamps
flashes.
12 Warranty
The statutory warranty period applies. If the product is defective, please contact your retailer or the manufacturer's
branch in your country (see dometic.com/dealer).
For repair and warranty processing, please include the following documents when you send in the product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
20
Possible cause
The battery clamps are
short circuited.
The battery clamps are
connected incorrectly.
The battery clamps have
not activated within
30 seconds.
The battery clamps are not
connected.
The high voltage protec-
tion of the battery clamps
is active.
The low voltage protection
of the battery clamps is
active.
The short circuit protection
of the battery clamps is
active.
The reverse polarity pro-
tections of the battery
clamps is active.
The high temperature pro-
tection of the battery
clamps is active.
The start of the battery
clamps is in progress.
The reverse charging pro-
tection is active.
The battery clamps are in
stand-by mode.
Suggested remedy
➤ Reconnect the battery clamps (see chapter
"Jump-starting vehicles" on page 16).
➤ Reconnect the battery clamps (see chapter
"Jump-starting vehicles" on page 16).
➤ Connect the jump starter to the starting battery
(see chapter "Connecting the battery clamps
(fig. 6, page 6)" on page 17).
➤ Ensure that the voltage is not too high (> 16.7 V).
➤ Charge the jump starter (see chapter "Charging
the jump starter" on page 15).
➤ Reconnect the battery clamps (see chapter "Con-
necting the battery clamps (fig. 6, page 6)" on
page 17).
The battery clamps switch off automatically when the
operating temperature is too high (> 80°C).
➤ Let the battery clamps cool down.
➤ Wait 30 seconds.
➤ If necessary, reconnect the battery clamps (see
chapter "Connecting the battery clamps (fig. 6,
page 6)" on page 17).
The battery clamps switch off the connection to the
jump starter automatically.
➤ Ensure the battery clamps are connected cor-
rectly (see chapter "Connecting the battery
clamps (fig. 6, page 6)" on page 17).
The flashing stops when the battery clamps are put
back into operation.
PJS1000
EN
Hoofdstukken
Inhoudsopgave
Probleemoplossen
