Ryobi RJS980 Vertaling Van De Originele Handleiding pagina 4
KNOW YOUR PRODUCT
See page 81.
1. Trigger switch
2. Lock-on button
3. Speed control dial
4. Blade clamp releaser
5. Blade guard
6. Blade
7. Allen key
8. Power cord sleeve
9. Blower switch
10. Orbital adjustment knob
11. Base assembly
12. Dust port
13. Line assist assembly
14. Handle, insulated gripping surface
MAINTENANCE
WARNING
The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
■
When servicing, use only original manufacturer's
replacement parts, accessories and attachments.
Use of any other parts may create a hazard or cause
product damage.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
■
Always wear safety goggles or safety glasses with
side shields when operating or cleaning the product. If
operation is dusty, also wear a dust mask.
■
Clean the product using a brush or a dust collection
system.
WARNING
Do not use compressed air to blow dust/dirt from any
power tool. Dirt and grit blown away by compressed air
can cause serious eye injury.
■
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
■
For greater safety and reliability, all repairs should be
2
performed by an authorised service centre.
■
All of the bearings in the product are lubricated with
a sufficient amount of high grade lubricant for the life
span of the product under normal operating conditions.
Therefore, no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
V
Volts
Hz
Hertz
Alternating current
W
Watts
n
No-load speed
o
min¹־
Revolutions or reciprocations per minute
Class II tool, double insulation
Please read the instructions carefully before
starting the machine.
CE conformity
EurAsian Conformity Mark.
Ukrainian mark of conformity
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
SYMBOLS IN THIS MANUAL
Connect to the power supply.
Disconnect from the power supply.
English
