Ryobi RLM36B41H Handleiding pagina 6
■
Remove all foreign materials from the product.
Store the product in a cool, dry, and well-
ventilated place that is inaccessible to children.
Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Do not store the product outdoors.
■
For transportation in vehicles, remove the
isolator key, and secure the product against
movement or falling to prevent injury to
persons or damage to the product.
■
Use extreme caution when lifting or tilting
the product for maintenance, cleaning,
storage, or transportation. The blade is
sharp. Keep all body parts away from the
blade while it is exposed.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging and
labelling when transporting batteries by a third
party. Ensure that no batteries can come in contact
with other batteries or conductive materials while
in transport by protecting exposed connectors with
insulating, non-conductive caps or tape. Do not
transport batteries that are cracked or leaking. Check
with the forwarding company for further advice.
MAINTENANCE
■
Use
only
original
replacement
parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■
Servicing
requires
knowledge and should be performed only by a
qualified service technician. Have the product
serviced by an authorised service centre only.
■
Turn off the product, and remove the isolator
key and the battery pack. Make sure that all
moving parts have come to a complete stop
before any cleaning or maintenance task.
■
Replace worn or damaged parts for safety.
■
Frequently check the grass catcher for wear
or deterioration.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition.
■
Be careful during adjustment of the product
to prevent entrapment of the fingers
between moving blades and fixed parts of
the product.
6
Original Instructions
manufacturer's
accessories,
and
extreme
care
and
■
When servicing the blades, be aware that
even though the power source is turned off,
the blades can still be moved.
■
You may make adjustments and repairs
described in this manual. For other repairs,
have the product serviced by an authorised
service centre only.
■
After each use, clean the plastic parts with
a soft, dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■
The blade on the product is sharp. Use
extreme caution, and wear heavy-duty
gloves when fitting, replacing, cleaning, or
checking bolt security.
■
The blade bolts must be adequately
tightened.
See
recommendations for blade bolt torque,
which can be found in the product
specification table in this manual.
CLEARING BLOCKAGES
■
Turn off the product, and remove the isolator
key and the battery pack. Make sure that all
moving parts have come to a complete stop.
■
Always wear heavy-duty gloves when
checking or clearing a blockage. The blades
are sharp, and the blockage itself could be
a sharp object.
■
Remove the grass catcher. Check and
carefully clear the grass catcher for
obstructions.
■
Check the grass discharge chute, and
carefully clear blockages.
■
Turn the product on its side. Check
its underside and the area around the
blade. Carefully remove any blockages.
Remember that the blade may move during
cleaning.
KNOW YOUR PRODUCT
See page 143.
1.
On/off lever
2.
Start button
3.
Motor control cable
4.
Telescopic handle
5.
Handle lock
6.
Grass catcher full indicator
7.
Grass catcher
8.
Quick-release fastener
9.
Cutting height adjustment lever
10. Battery door
11. Rear wheel
the
manufacturer's
