Parkside PWS 125 I8 Bedienings- En Veiligheidsinstructies pagina 45
Verberg thumbnails
Zie ook voor PWS 125 I8:
- Bedienings- en veiligheidsinstructies (73 pagina's) ,
- Bedienings- en veiligheidsinstructies (91 pagina's)
Beschikbare talen
Beschikbare talen
Depending on the method of
o
working, tighten the handle on to the
handle thread on the left
g
or top
[
2 ]
˜ Adjusting the protective
NOTE
The protective cover
u
installed on the product.
Re-adjust the position of the
u
protective cover
during use that it does not provide
optimum protection.
Adjust the protective cover such that
o
any sparks or detached parts cannot
hit either the user or any bystanders.
The protective cover must also be
o
positioned such that the sparks
cannot ignite combustible parts,
including those in the surroundings.
Removing the protective cover
Take o the protective cover
o
removing the screws
of a suitable screwdriver see g
˜ Fitting the attachment to/
removing the attachment
from the protective
E
Fitting the attachment
1. Fit the attachment for the protective
cover
in direction a onto the
[
]
protective cover
2. Push the attachment onto the
protective cover until it clicks into
place.
, right
7 ]
[
of the product.
D
is pre-
9 ]
[
if you nd
9 ]
[
by
9 ]
[
with the help
[
]
.
9 ]
[
Removing the attachment
1. Release the attachment for the
protective cover
notch
away from the protective
[
]
cover
.
9 ]
[
2. Unscrew the attachment from the
protective cover.
˜ Installing/demounting
F
1. Press the spindle lock button
2. Turn the mounting spindle
the spindle lock
spindle. Keep and continue to hold
down the spindle lock button.
3.
elease the clamping nut
chuck key
. You can release the
[
]
spindle lock button.
4. Set the desired disc onto the
mounting ange
on the disc should always face the
product.
NOTE
If the rotary direction is indicated
u
on your disc, ensure that it
corresponds to the rotary direction
of the product when mounting.
This is indicated on the product
next to the spindle lock button
(
Ensure that the mounting ange
u
g
is placed on the product
in such a way that the recesses
in the ange grip into the edge of
the product. The mounting spindle
must turn simultaneously when you
turn the ange
5. Set the clamping nut on the
mounting spindle again The at side
of the clamping nut must face the
attachment tool if the thickness of
the disc receptor is
by pushing the
[
]
.
[
]
until
[
]
ed the mounting
with the
[
]
g
The label
[
]
5 mm
GB/IE
43
