Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Standby
If the drive of the extruder is switched off and no key input is made for a certain time, the cool down mode starts
automatically after the standby time has elapsed.
Setting the standby time
This menu is used to activate and set the standby time.
Press the
key to switch standby on or off.
Press the
and
The factory setting is 40 minutes.
Press the
key to return to Work mode.
26
The cooling process is initiated.
If any key is pressed before the countdown has elapsed in standby mode (180 seconds),
the display returns to the initial state.
If no key is pressed during the countdown, the cool down mode starts. Pressing any key
heats up the extruder again and the work display switches to Work mode.
keys to set the time from 5-120 minutes.
Advertenties
Inhoudsopgave
