Energy-Saving Features; Troubleshooting; No Picture/Picture Interference; Incorrect Colour Reproduction; Image Is Too Bright/Dark - Medion ERAZER Spectator X50 Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor ERAZER Spectator X50:
- Handleiding (40 pagina's) ,
- Gebruiksaanwijzing (15 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Auto Power Off
If this function is activated, the device
automatically switches to standby mode
after 4 hours of inactivity (no operation of
the device).
• Sleep
Activate/deactivate sleep mode to switch
to standby mode when inactive. Select
the following options: 30, 45, 60, 120
Minutes, Off
• ECO Mode
Select the desired energy saving mode:
Standard, Optimize, Conserve
• DDC/CI
Activate/deactivate monitor control via
the connected computer.
• Memory Recall
Reset the monitor to the factory settings.
Close the menu
9. Energy-saving features
This monitor switches to different energy-saving modes,
which are specified by the respective computer/operating
system. This complies with the current requirements for
reducing the energy consumption.
The monitor supports the following types of energy-sav-
ing modes:
Power con-
sumption
Status
(nominal
value)
ON
< 40 W (max.)
STANDBY
< 0.5 W
EXT.
< 0.5 W
STANDBY
Depending on the operating system, the monitor remains
in energy-saving mode until you press a button on the
keyboard or move the mouse. The monitor requires about
2 seconds to switch from standby mode to operating
mode "On".
12
Colour of
Ready for
the
operation
operating
(approx.)
light
Blue
–
Orange
2 seconds
–
5 seconds
10. Troubleshooting
If problems occur with your monitor, make sure that the
monitor has been properly installed. If the problems per-
sist, then read this section for information about possible
solutions.
10.1. No picture/picture interference
• The mains cable must be firmly seated in the socket
and the power switch (if available) must be switched
on.
• The computer must be switched on and the connect-
ing cable must be firmly seated in the socket.
• The set values of the operating system must be suita-
ble for the monitor. To avoid distortion, select a resolu-
tion of 16:9.
• If the screen saver is activated or the monitor is in
standby mode, press any button on the keyboard or
move the mouse.
• Move the devices responsible for the distortion (mo-
bile phones, speakers) away from your monitor.
10.2. Incorrect colour reproduction;
image is too bright/dark
• Check the colour settings in the display menu or in the
computer's operating system.
11. Cleaning
• Always unplug the device and disconnect all cables
before cleaning.
• Do not use solvents, corrosive or gaseous cleaning
agents.
• Clean the display screen with a soft, lint-free cloth.
• Take care to ensure that no water droplets remain on
the display screen. Water can cause permanent discol-
ouration.
• Store the packaging material in a safe place. Only use
this box to transport the monitor.
The monitor housing does not contain any parts that re-
quire cleaning or maintenance.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
