The Water Heater Rate May Change In The Conditions Below; Winter Use Instructions - Bestway Lay-Z-Spa Gebruikershandleiding
Verberg thumbnails
Zie ook voor LAY-Z-SPA:
- Gebruikershandleiding ,
- Handleiding (340 pagina's) ,
- Handleiding (28 pagina's)
Inhoudsopgave
Beschikbare talen
Beschikbare talen
USAGE INSTRUCTIONS
MASSAGE SYSTEM BUTTON: Press the
a 30-minute auto-shutoff feature. The light of the button becomes red when activated.
Do not run the massage system when the cover is attached. Air can accumulate inside the hot
tub and cause irreparable damage to the cover. The heat and massage system can be activated
at the same time.
FOR WI-FI ENABLED HOT TUBS ONLY:
2-LEVEL MASSAGE REGULATION: Push once for the full-power massage (L1). Push
again for a lower power massage (L2). Push it a third time to shut the massage function off.
When inflating the hot tub liner, make sure that the massage function is running at full power.
WATER FILTER BUTTON: The
up red when activated.
FOR WI-FI ENABLED HOT TUBS ONLY:
WI-FI ACTIVATION: For Wi-Fi and smartphone app operation instructions, read the hot tub
Wi-Fi instruction leaflet included in the package.
THE WATER HEATER RATE MAY CHANGE IN THE
CONDITIONS BELOW:
• When the outdoor temperature is below 15°C (59°F).
• If the cover is off or not in the correct position. Always keep the cover on the hot tub
when it is heating up or is not in use; it minimizes heat loss while preventing dust
from contaminating the water.
• The water temperature shown on the display may not be correct if the filtration system is not activated.
To read the correct water temperature on the display, run the filtration system for at least a minute.
• The water temperature as tested by an external thermometer may vary from the temperature as
displayed on the hot tub panel by as much as approximately 3°C (37.4°F).
WINTER USE INSTRUCTIONS
It is important to follow these guidelines if you are setting up the hot tub
during the winter. This will prevent damage to the hot tub heater and
liner material, drastically extending the life of the product.
• If the outdoor temperature is below 15°C (59°F), unfold and inflate the hot tub indoors using the hot tub
pump to avoid damaging the liner. This will make the hot tub liner more flexible and easier to set up.
• Continue setup outdoors by positioning the hot tub liner in the desired area, then connect the hot tub
pump and fill with water. The water temperature used to fill the hot tub must be above 6°C (42.8°F),
otherwise when you start the hot tub heater, the E03 alarm will appear.
• If the Freeze Shield
®
continuously check the status of your hot tub if the outdoor temperature is below 6°C (42.8°F).
If you have a long-term absence from your home when there is a risk of temperatures falling below
6°C (42.8°F), we strongly suggest disassembling the hot tub and storing it following the Disassembly
and Storage Instructions.
• Any damage due to using the hot tub in these conditions is the responsibility of the customer. Do not
use the hot tub when the outdoor temperature reaches -10°C (14°F); follow the Disassembly and
Storage Instructions for proper procedures.
system isn't working, alarms will appear on the display screen. Be sure to
button to activate the massage system, which has
button turns the filter pump on and off. The
14
button lights
FREEZE SHIELD
®
Inhoudsopgave
