Bestway LAY-Z-SPA Gebruikershandleiding pagina 18
Verberg thumbnails
Zie ook voor LAY-Z-SPA:
- Gebruikershandleiding ,
- Handleiding (340 pagina's) ,
- Handleiding (16 pagina's)
Inhoudsopgave
Beschikbare talen
Beschikbare talen
TROUBLESHOOTING
Problems
Pump stopped
working
Pump is not
heating properly
with lid
Massage system
is not working
Hot tub air is
leaking
Water is not
clean
RCD/PRCD
test failed
Control panel is
not working
Probable Causes
Power failure.
Power circuit is broken.
Temperature set too low.
Dirty filter cartridge.
Hot tub is not covered
properly with lid.
Heating element failure.
Air pump is overheating.
Massage stops automatically
after 30 minutes.
Air pump is broken.
Hot tub is torn or punctured.
Safety valve is loose.
Insufficient filtering time.
Dirty filter cartridge.
Improper water maintenance.
Hot tub or RCD/PRCD
is defective.
The control panel has an
auto-lock, which is activated
after 5 minutes of inactivity; if
the lock icon
is highlighted,
the control panel is locked.
Control panel is not activated.
Check power source.
For assistance, please visit the support section on our
website, www.bestwaycorp.com.
Set the hot tub to a higher temperature; refer
to pump operation section.
Clean/replace the filter cartridge (refer to Filter Cartridge
Cleaning and Replacement section).
Properly attach the cover.
For assistance, please visit the support section on our
website, www.bestwaycorp.com.
Unplug the pump, wait two hours until the pump is cool,
insert the plug and press the Massage System Button.
Press the Massage System Button to reactivate.
For assistance, please visit the support section on our
website, www.bestwaycorp.com.
Use provided repair patch
The safety valve starts to release air when the inner
pressure is too high. To check if there is air leakage
from the valve, follow these steps:
1. Inflate the liner with the hot tub pump.
2. Use soapy water and a cloth to wipe around the safety
valve; if you see bubbles, there is a leak.
• If there is a leak around the safety valve, tighten the
valve by turning it clockwise.
• If there is a leak in the center of the safety valve,
please visit the support section on our website:
www.bestwaycorp.com.
Increase filtration time.
Clean/replace the filter cartridge (refer to Filter Cartridge
Cleaning and Replacement section).
Refer to the chemical manufacturer's instructions.
For assistance, please visit the support section on our
website, www.bestwaycorp.com.
1. To unlock the control panel, press the
3 seconds. If the control panel will not unlock, restart the
pump – unplug and plug it back in.
2. Press the
button for 2 seconds if the problem persists.
For assistance, please visit the support section on our
website, www.bestwaycorp.com.
18
Solutions
button for
Inhoudsopgave
