Advertenties
All manuals and user guides at all-guides.com
11. Indicators on the charging station and troubleshooting
LED indicator (21)
Off
- No power supply
Lit up green
- Ready for mowing
- Rechargeable battery (22) is
- Perimeter wire (18) is cor-
Flashing green
- Perimeter wire (18) is se-
- Perimeter wire (18) is not
Lit up red
- Rechargeable battery (22) is
12. Indicators on the robot lawn mower and troubleshooting
The alarm LED (53) is lit up red
Fault
"Robot lawn mower
- The lifting sensor has been
has lifted".
"Robot lawn mower
- The obstruction sensor has
is stuck"
The robot lawn
mower has come
to a stop near an
obstacle.
Anl_GC_RM_500_SPK9.indb 39
Anl_GC_RM_500_SPK9.indb 39
GB
Description
fully charged
rectly installed
vered
properly connected
charging
Possible cause
continually tripped for 10 se-
conds
tripped 10 times within one
minute
- 39 -
Solution
- Check the power supply
- Inspect the perimeter wire (18) for a break
- Check the two connections on the char-
ging station (19)
- Wait until the rechargeable battery (22) is
fully charged.
Remedy
Press the "OK" button (54) to reset the error.
Re-start the mowing operation on the control
panel (2).
- If this fault occurs frequently, check the
mowing area for obstacles taller than 10
cm and either remove them or cordon
them off from the mowing area with peri-
meter wire (18).
Press the "OK" button (54) to reset the error.
Re-start the mowing operation on the control
panel (2).
- Check whether the robot lawn mower
is blocked by an obstacle or jammed
between trees, bushes, etc. Remove the
obstacle or avoid this area.
- If this fault occurs frequently, check the
way in which the perimeter wire (18) has
been laid. Pay particular attention to tight
angles, corridors, fences, rocks, etc., and
adjust the layout of the perimeter wire (18)
if necessary.
- Check whether the grass is too tall and
the robot lawn mower gets blocked. If this
is the case, mow the grass to below 60
mm.
16.02.2021 14:17:34
16.02.2021 14:17:34
Advertenties
