EINHELL GC-RM 500 Originele Handleiding pagina 43
Inhoudsopgave
All manuals and user guides at all-guides.com
Troubleshooting
Fault
The robot lawn mo-
- Battery voltage too low
wer comes to a stop
- Fault in the power circuit or
in the mowing area.
The robot lawn
mower cannot be
switched on:
The robot lawn
- The charging station (19) is
mower cannot move
into the charging
station.
The robot lawn mo-
- The perimeter wire (18) has
wer stops or travels
out of control when
near perimeter is-
lands.
The robot lawn mo-
- Damaged blades (10)
wer is very loud.
- A large amount of foreign
- The robot lawn mower has
- Damaged blade drive or
- Other parts of the robot lawn
The robot lawn
- Incorrect work time settings
mower stays in the
- The rechargeable battery
charging station.
The robot lawn mo-
- The rain sensor has been
wer keeps returning
to the charging
- The battery temperature is
station
The robot lawn mo-
- The battery (22) is empty
wer comes to a halt
on the perimeter
wire and is unable
to get back to the
charging station.
IMPORTANT! Severed perimeter wires and consequential damages are not covered by the war-
ranty!
Anl_GC_RM_500_SPK9.indb 43
Anl_GC_RM_500_SPK9.indb 43
GB
Possible cause
the electronic components
not installed correctly.
not been installed correctly
around the perimeter islands.
bodies adhere to the blades
(10)
started too close to obstac-
les
drive motor
mower are damaged
(22) is empty
triggered
high
- 43 -
Remedy
- Bring the robot lawn mower back to the
charging station (19) for charging.
- Switch on the main switch (7) (ON).
- Contact your customer service center.
- Make sure that the LED indicator (21) on
the charging station (19) is lit up green.
- Make sure that the perimeter wires (18)
are connected at the charging station (19)
and that the front perimeter wire (18) is
laid in the middle underneath the charging
station (19).
- Make sure that the charging station (19) is
positioned correctly.
- Adjust the position of the perimeter wire
(18).
- Make sure that the perimeter wire (18)
does not cross over itself
- - Replace the blades (10). The 3 blades
(10) must all be replaced together at the
same time.
- The operating effi ciency of the robot lawn
mower is dependent on the sharpness of
the blades (10). You should therefore en-
sure that the blades (10) are maintained in
good condition.
- Switch off the robot lawn mower safely
and wear work gloves while you clean the
blades (10) in order to avoid getting cut.
- Arrange for the motor to be repaired or
replaced by your customer service center.
- Check the work time settings.
- The robot lawn mower will begin and end
its work in accordance with the set time
window. Outside this time window the
robot lawn mower stays in the charging
station (19).
- Remove all possible obstacles from the
perimeter wire (18). When you layout out
the perimeter wire (18), be sure to keep it
far enough away from any obstacles.
16.02.2021 14:17:34
16.02.2021 14:17:34
Hoofdstukken
Inhoudsopgave
