Parkside PSTDA 20-Li C3 Vertaling Van De Originele Gebruiksaanwijzing pagina 17
Verberg thumbnails
Zie ook voor PSTDA 20-Li C3:
- Vertaling van de originele gebruiksaanwijzing (64 pagina's)
Beschikbare talen
Beschikbare talen
• Remove the battery from the
device before storage over a longer
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Device works with inter-
ruptions
Poor sawing performance
Saw blade quickly be-
comes blunt
Possible cause
Rechargeable battery (4)
not inserted
On/Off switch (2) is
broken
Rechargeable battery (4)
discharged
Defective motor
Internal loose contact
On/Off switch (2) is
broken
Saw blade (16/17/18) un-
suitable for the workpiece
to be processed
Saw blade (16/17/18)
blunt
Low battery power
Incorrect sawing speed
Saw blade (16/17/18) un-
suitable for the workpiece
to be processed
Too much pressure ap-
plied
Sawing speed too high
period (see separate operating in-
structions for battery and charger).
Error correction
Inserting the battery,
p. 16
Contact the service
centre.
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Contact the service
centre.
Contact the service
centre.
Contact the service
centre.
Use a suitable saw blade
(16/17/18)
Use a new saw blade (16/
17/18)
Charge the battery (see
the separate operating
instructions for the re-
chargeable battery and
charger)
Adjust sawing speed
Use a suitable saw blade
(16/17/18)
Reduce the pressure
Reduce the sawing speed
GB
IE
NI
17
