Char-Broil ESSENTIAL Series Gebruiksinstructies pagina 4
Beschikbare talen
Beschikbare talen
NOTE: Your barbecue may NOT be equipped with a Hot plate!
Hot plate Ignitor Lighting
• Do not lean over barbecue while lighting.
1.
Turn gas burner control valves to
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
Turn hot plate knob to the
HIGH position, push and hold ELECTRONIC
IGNITOR button.
5.
If hot plate does NOT light within 5 seconds, turn knob to
minutes, then repeat lighting procedure.
Hot plate Match Lighting
• Do not lean over barbecue while lighting.
1.
Turn gas burner control valves to
2.
Open lid during lighting or re-lighting.
3.
Turn ON gas at LP cylinder.
4.
Place lit match near burner. Immediately turn hot plate knob to the
position. Be sure burner lights and stays lit.
(off).
(off), wait 5
(off).
HIGH
Leak Testing Valves, Hose and Regulator
Leak test before first use, at least once a year, and every time the cylinder is changed
or disconnected.
1. Turn all appliance control knobs to OFF.
2. Be sure regulator is tightly connected to gas cylinder.
3. Turn on Gas. If you hear a rushing sound, turn gas off immediately. There is a major
leak at the connection. Correct before proceeding.
4. Brush soapy solution (mixture of half soap and half water) onto hose connections.
5. If "growing" bubbles appear, there is a leak. Turn off gas at cylinder immediately
and check tightness of connections. If leak cannot be stopped do not try to
repair. Call for replacement parts.
6. Always turn off gas at cylinder after performing leak test.
IF APPLIANCE FAILS TO LIGHT
• Make sure gas is turned on at cylinder.
• Make sure there is gas in the cylinder.
• Does the ignitor make a sparking noise?
If yes check for spark at burner.
If no spark check for damaged or loose wires.
• If wires are OK check for cracked or broken electrode, replace if needed.
• If wire or electrodes are covered by cooking residue, clean electrode tip with
alcohol wipe if needed.
• If needed replace wires.
• If no sound check battery.
• Make sure battery is installed correctly.
• Check for loose wire connection at module and switch.
• If ignitor continues to not work then use match.
CAUTION
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER
If your barbeque is getting hard to light or the flame is weak, check and clean the
venturis and burners.
Spiders or small insects are known to create "flashback" problems by building nests
and laying eggs in the barbeque's venturi or burner obstructing the flow of gas. The
back-up gas can ignite behind the control panel. This flashback can damage your
barbeque and cause injury. To prevent flashbacks and ensure good performance,
the burner and venturi tube assembly should be removed and cleaned whenever the
barbeque has been idle for an extended period of time.
GB
4
Your burner might be different
C H A R B R O I L . E U
