VEVOR YCS-90 Handleiding pagina 3
Stoomgenerator
IMPORTANT SAFGUARDS
Warning：- To reduce the risk of injury, user must read instructions manual
carefully.
If the machine is installed in a place where it is difficult for users to operate, the
water supply valve must be installed in a place where it is easy to operate in case
of emergency.
The withstand pressure of the solenoid valve is 2 kg/cm2. If the water pressure is
too high, in order to avoid damage to the solenoid valve, it is appropriate to turn
down the inlet valve or add an inlet pressure-reducing valve.
The saddle valve or needle valve cannot be installed on the water inlet pipe. The
water pipe shall be dredged and flushed before the final connection.
It is forbidden to install blocking valves in steam pipes. Blocking or bending the "U"
channel is strictly forbidden. Otherwise, condensed water will be produced to block
the flow of steam. The steam pipe shall be inclined to a certain extent when it is
laid horizontally so that the condensate can flow back to the steam generator or to
the steam nozzle.
The steam generator cannot be installed outdoors to prevent icing inside. It must
be installed in a place convenient for maintenance. The machine should be
installed horizontally, and the arrow direction should be upward. Otherwise, it
cannot be started.
The pipe installation must be made of copper pipe. It is forbidden to use plastic,
acrylic, aluminum-plastic pipe, or other similar materials as steam pipes because
the allowable temperature of these materials cannot reach 150 ℃ or higher.
The steam pipe inlet and all other inlets and gaps shall be sealed to prevent steam
leakage from damaging the machine and other objects.
Draining the water in the water tank into the steam room may cause scald
accidents and damage the building materials used in the steam room.
Warning：
All power switches must be disconnected before installing, maintaining, and
maintaining the machine.
It is forbidden to connect any additional wires or provide power to the machine and
2
