Parkside PMSHM2 A3 Bedienings- En Veiligheidsinstructies pagina 14
Verberg thumbnails
Zie ook voor PMSHM2 A3:
- Bedienings- en veiligheidsinstructies (75 pagina's) ,
- Bedienings- en veiligheidsinstructies (127 pagina's) ,
- Bedienings- en veiligheidsinstructies (181 pagina's)
Beschikbare talen
Beschikbare talen
Before using
Before initial use, remove the protective
film from the product display
insert the enclosed batteries.
Before using the product, keep the product
under room environment for minimum 1 hour
to stabilise and to perform better.
Inserting/changing
the batteries
If the battery symbol
display, the inserted batteries are almost
drained and must be replaced. Empty batteries
can falsify the measured result.
To insert the batteries proceed as follows:
Open the battery compartment cover
on the back of the product.
Remove the used batteries.
Insert two 1.5 V , type LR03, AAA batteries
into the battery compartment
attention to the correct polarity.
Close the battery compartment cover
again so that it audibly latches into place.
Note: No button should be pressed while
inserting the batteries.
Switching on and off/
Automatic shut-down
Briefly press the ON/OFF button
switch the product on or off.
Note: If you do not press any button for
one minute after the product has been
switched on, the product automatically
switches off.
14 GB/IE/NI
appears in the
14
and
2
10
. Pay
9
10
to
7
