Parkside PMSHM2 A3 Bedienings- En Veiligheidsinstructies pagina 17
Verberg thumbnails
Zie ook voor PMSHM2 A3:
- Bedienings- en veiligheidsinstructies (75 pagina's) ,
- Bedienings- en veiligheidsinstructies (127 pagina's) ,
- Bedienings- en veiligheidsinstructies (181 pagina's)
Beschikbare talen
Beschikbare talen
into the intended slot of the pencil
5
hole on the product. When necessary,
the pencil
pencil hole.
If one (or) a few more bars appear on the
display whilst slow scanning repeatedly
at a particular location of a wall, there
could be an object, for which the search
is activated present in that part of the
wall. Due to an air-gap inside the wall
(or) other similar issue not, not all full
bars are observed and no beep sounds.
In this case, scan by moving fast one (or)
more time(s). All full bars will be observed
and beep sounds during fast movement
scanning at that particular location to
confirm the presence of the searched
object.
There are three sensitivity levels (I, II, III)
of AC power line search. It can be adjusted
using AC Sens slide switch
lowest sensitivity level, II is the middle
sensitivity level, III is the highest sensitivity
level. In the case of power line unable to
be detected in level I, switch to II or III to
get the higher sensitivity level and to
perform the detection again.
Note: These sensitivity levels are applied
in AC power line search mode only.
Tips on measurement
The PUSH button
during the entire search process (calib-
ration and search).
If you calibrate too closely to the object
or directly on the object, the calibration
can fail. If the calibration fails, the LC
display shows the full intensity (Fig. C)
can be taken out from the
5
must remain pressed
6
. I is the
3
GB/IE/NI
17
