Parkside PIFDS 120 B2 Bedienings- En Veiligheidsinstructies pagina 7
Verberg thumbnails
Zie ook voor PIFDS 120 B2:
- Bedienings- en veiligheidsinstructies (89 pagina's) ,
- Bedienings- en veiligheidsinstructies (238 pagina's) ,
- Bedienings- en veiligheidsinstructies (349 pagina's)
Beschikbare talen
Beschikbare talen
Greatest rated value of the welding
time in intermittent mode Σ
INVERTER FLUX CORED WIRE WELDER PIFDS 120 B2
z Introduction
Congratulations!
You have purchased one of our high-quality devices. Please familiarise yourself
with the product before using it for the first time. To do this, please read through
the following operating and safety instructions carefully. This tool must be set up or used only by
people who have been trained to do so.
KEEP OUT OF REACH OF CHILDREN!
z Intended use
The device is suitable for self-shielded flux cored wire welding using an appropriate wire. No addi-
tional gas is required. The shielding gas is contained in powder form in the wire itself, thus it is fed
directly into the arc. This means the device is not susceptible to wind and can be used outside. Only
suitable wire electrodes may be used for the device. Observing the safety instructions and assem-
bly instructions and operating information in the instructions for use is also a component of the
intended use.
It is imperative to adhere to the applicable accident prevention regulations. The device must not be
used:
– in rooms with insufficient ventilation,
– in explosive atmospheres,
– for the purpose of thawing pipes,
– in the vicinity of people with cardiac pacemakers and
– in the vicinity of easily inflammable materials.
Use the product only as described and only for the specific applications as stated. Store these
instructions in an easily accessible place. Ensure you hand over all documentation when passing the
product on to anyone else. Any use that differs to the intended use as stated above is prohibited and
potentially dangerous. Damage from non-observation or wrong use is not covered by the warranty
and is not subject to the manufacturer's liability. The device is not intended for commercial use.
Commercial use will void the guarantee.
z Package contents
1 Inverter Flux Cored Wire Welder PIFDS 120 B2
1 torch nozzle (pre-mounted)
4 welding nozzles (1x 0.9 mm pre-mounted; 1x 0.8 mm; 1x 0.6 mm; 1x 1.0 mm)
1 chipping hammer with wire brush
1 flux cored wire Ø 0.9 mm / 450 g
1 welding protection shield
1 carry strap
1 set of operating instructions
t
ON
Greatest rated value of the welding
time in continuous mode Σ
GB
t
ON (max)
7
