Parkside PIFDS 120 B2 Bedienings- En Veiligheidsinstructies pagina 9
Verberg thumbnails
Zie ook voor PIFDS 120 B2:
- Bedienings- en veiligheidsinstructies (89 pagina's) ,
- Bedienings- en veiligheidsinstructies (238 pagina's) ,
- Bedienings- en veiligheidsinstructies (349 pagina's)
Beschikbare talen
Beschikbare talen
z Technical specifications
Power supply:
Welding current I
:
2
No-load voltage U
:
0
Greatest rated value of the mains power:
Effective value of the greatest rated current:
Welding wire reel max.:
Welding wire diameter max.:
Fuse:
Recommended material thickness:
Technical and visual changes may be made in further development without notifying the customer.
All dimensions, notices and specifications in the operating instructions are therefore subject to
change. The operating instructions cannot therefore be used as the basis for asserting a legal claim.
z Safety instructions
Please read the operating instructions with care and observe
the notes described. Familiarise yourself with the device, its proper
use and the safety instructions using these operating instructions.
The rating plate contains all technical data of this welder; please
learn about the technical features of this device.
Repairs and/or maintenance work must only be carried out by
„
qualified electricians.
Only use the welding cables provided in the scope of delivery.
„
During operation, the device should not be positioned directly
„
against the wall, covered or jammed between other devices so
that sufficient air can always be absorbed through the ventila-
tion slats. Make sure that the device is correctly connected to
the mains voltage. Avoid any form of tensile stress of the power
cable. Disconnect the mains plug from the socket prior to setting
up the device in another location.
If the device is not in operation, always switch it off by pressing
„
the ON/OFF switch. Place the electrode holder on an insulated
surface and only remove the electrodes from the holder after
allowing it to cool down for 15 minutes.
Pay attention to the condition of the welding cable, torch and the
„
earth clamps. Wear and tear of the insulation and the live parts
can lead to hazards and reduce the quality of the welding work.
230 V~ / 50 Hz (alternating current)
20–120 A
22 V
I
17.3 A
1 max.
I
11.3 A
1eff
approx. 1000 g
1.0 mm
16 A
0.8–3.0 mm
GB
9
