Cleaning And Disinfecting; Transportation And Storage - Pulox Po-400 Gebruiksaanwijzing
Pulsoximeter
Inhoudsopgave
Beschikbare talen
Beschikbare talen
6.6 Reset
Use a pointed and hard object (for example, a paper clip) to press the reset button inside of the
RESET hole, to reset the device.
7. Maintain, Transportation and Storage
7.1 Cleaning and Disinfecting
The device must be turned off before cleaning, and it should not be immersed into liquid. Use 75%
alcohol to wipe the device enclosure, and use liquid soap or isopropanol to wipe the watchband
for disinfection, nature dry or clean it with clean and soft cloth. Do not spray any liquid on the
device directly, and avoid liquid penetrating into the device.
7.2 Maintain
A. Please clean and disinfect the device before using according to the User Manual (7.1).
B. Please recharge the battery when the screen shows .
C. Recharge the battery soon after the over-discharge. The device should be recharged every six
months when it is no regular used. It can extend the battery life following this guidance.
7.3 Transportation and Storage
A. The packed device can be transported by ordinary conveyance or according to transport
contract. The device can not be transported mixed with toxic, harmful, corrosive material.
B. The packed device should be stored in room with no corrosive gases and good ventilation.
Temperature: -40°C~60°C; Humidity: ≤95%
8. Troubleshooting
Trouble
The SpO2 and Pulse Rate can
not be displayed normally
The SpO2 and Pulse Rate are
not displayed stably
The device can not be turned
on
The display is off suddenly
The device can not be used
for full time after charge
The battery can not be full
charged even after 10 hours
charging time.
Possible Reason
1. The finger is not properly
positioned
2. The patient's SpO2 is too
low to be detected.
1. The finger is not placed
inside deep enough.
2. The finger is shaking or the
patient is moving.
1. The batteries are drained
or almost drained.
2. The device's malfunction
1. The device's malfunction.
2. The battery is drained
away or almost drained away.
The battery is not full
charged.
The battery is broken
The battery is broken
Solution
1. Place the finger properly
and try again.
2. Try again; Go to a hospital
for a diagnosis if you are sure
the device works all right.
1. Place the finger properly
and try again.
2. Let the patient keep calm
1.Please recharge the battery
2. Please contact the local
service center.
1. Please contact the local
service center.
2.Please recharge the battery
1. Please recharge the
battery
2. Please contact the local
service center.
Please contact the local
service center.
EN
Inhoudsopgave
