Default Working Times - Thomson Thih4Flex Handleiding
Inhoudsopgave
Beschikbare talen
Beschikbare talen
LR
LF
Default Working Times
Auto shut down is a safety protection function for your hob. The hob will shut down automatically if you
forget to turn off the cooking zone. The default working times for various power levels are shown in the
below table:
Power level
Default working time (hour)
When the pot is removed, the hob will stop heating immediately and automatically switch off after
about 1 minute.
Pan Transfer Function
The pan transfer function is disabled by default and can be activated or disabled by performing the
following operations.
In the standby state, touch and hold LF (Left Front) zone timing reduction key
1. LF digital tube display On, it means open pan transfer function.
2. LF digital tube display OF, it means close pan transfer function.
3. The pan transfer function is not enabled by default when the hob is in boost mode.
4. After the transfer is confirmed, the set time and level will be transferred.
LR
Start LR (Left Rear)
zone at level 9.
When the flexible area is activated as a single big zone, the timer is turned
off by default. You can use the buttons
timer for operating the flexi zone.
If the Flexi zone function is deactivated, the LF (Left Front) zone will
continue the timer control mode.
Pause
1
8
8
LR
When the power is stable,
transfer the LR zone to RF
(Right Front) zone.
and/or
2
3
4
5
6
8
6
6
4
4
RF
The level will flash on the
display for the RF zone.
100
to set the
7
8
9
2
2
1,5
for about 3 seconds.
LR
RF
Hoofdstukken
Inhoudsopgave
Probleemoplossen
