To cancel the boost function
In boost mode, the operation of slider will exit the boost mode, and the level will be displayed.
Note
The function can work in all cooking zones.
The cooking zone returns to its original setting after 10 minutes.
The flex cooking zone returns to its original setting after 5 minutes.
As the boost function of 1st cooking zone is activated, start 2nd cooking area, and the 1st cooking
area will automatically change to level 9. Vice versa.
If the original heat setting equals 0, it will return to 9 after 10 minutes.
Flexible Area
This area can be used as a single zone or as two different zones, accordingly to the cooking needs
anytime.
Flexible area is made of two independent inductors that can be controlled separately. When working
as a single zone, the part that is not covered by cookware is automatically switched off after 8
seconds. Do not use bad pot placement on the Flexible area centered.
To grant a correct pan detection and a even heat distribution, the cookware should be correctly
placed:
in the front or rear side of the flexible zone when the cookware is smaller than 22 cm.
Anywhere with bigger cookware.
As big zone
To activate the flexible area as a single big zone, touch
The power setting works as any other normal area.
If the pot is moved from the front to the rear part (or vice versa), the flexible area detects automatically
the new position, keeping the same power.
If only one pot is detected, the indicator light
activate the flexi zone function. After adding a pot, touch
As two independent zones
To use the flexible area as two different zones with different power settings, touch
the flexi zone function. The indicator light
Do not use bad pot placement on the flexible area centered.
Examples of good pot placement and bad pot placement.
. The indicator light
will go out and you need to add a further pot to
again.
will go out.
98
will illuminate.
to deactivate