Electrical Connection - Thomson Thih4Flex Handleiding
Inhoudsopgave
Beschikbare talen
Beschikbare talen
dryers.
The hob shall be installed such that better heat radiation can be ensured to enhance
its reliability.
The wall and induced heating zone above the table surface shall withstand heat.
To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
A steam cleaner must not be used.
ELECTRICAL CONNECTION
Attention!
The hob must be installed by a qualified electrician in line with all local standards
and regulations for electrical wiring.
Before any work on the electrical section of the appliance, it must be disconnected
from the mains.
Connection to a good earth wiring system is absolutely essential.
All supply current and earth conductors must be able to withstand an ambient
temperature of 75°C.
After the hob is installed, the power switch must always be in an accessible
position.
The wires in the mains lead are coloured in accordance with the following
codes:
Green & Yellow = Earth
The appliance is equipped with a pre-connected electricity supply cable without plug.
Separate the wires of the supply cable and connect them in accordance with the
instructions given in the below diagram.
1 The wire which is coloured green and yellow must be connected to the terminal
marked with the letter E (Earth) or with the earth symbol
and yellow.
2 The wire which is coloured blue / grey must be connected to the terminal marked
N (Neutral).
3 The Brown and Black wires must be connected to the terminal marked L (Line).
If the appliance is being connected directly to the electricity mains, an
Blue & Grey = Neutral
92
Brown & Black = LINE
or coloured green
Hoofdstukken
Inhoudsopgave
Probleemoplossen
