Before Using; Inserting/Changing The Batteries; Switching On And Off/Automatic Shut-Down - Parkside Pmshm2 A3 Bedienings- En Veiligheidsinstructies
Verberg thumbnails
Zie ook voor PMSHM2 A3:
- Bedienings- en veiligheidsinstructies (127 pagina's) ,
- Bedienings- en veiligheidsinstructies (106 pagina's) ,
- Bedienings- en veiligheidsinstructies (181 pagina's)
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Remove exhausted batteries/recharge-
able batteries from the product imme-
diately.
Before using
Before initial use, remove the protective film from
the product display
batteries.
Before using the product, keep the product under
room environment for minimum 1 hour to stabilise
and to perform better.
Inserting/changing
the batteries
If the battery symbol
the inserted batteries are almost drained and must
be replaced. Empty batteries can falsify the measured
result.
To insert the batteries proceed as follows:
Open the battery compartment cover
back of the product.
Remove the used batteries.
Insert two 1.5 V, type LR03, AAA batteries into
the battery compartment
the correct polarity.
Close the battery compartment cover
so that it audibly latches into place.
Note: No button should be pressed while insert-
ing the batteries.
Switching on and off/
Automatic shut-down
Briefly press the ON/OFF button
the product on or off.
and insert the enclosed
2
appears in the display,
14
. Pay attention to
9
on the
10
again
10
to switch
7
GB/IE/NI
13
Hoofdstukken
Inhoudsopgave
