Start-Up - Parkside Pmshm2 A3 Bedienings- En Veiligheidsinstructies
Verberg thumbnails
Zie ook voor PMSHM2 A3:
- Bedienings- en veiligheidsinstructies (127 pagina's) ,
- Bedienings- en veiligheidsinstructies (106 pagina's) ,
- Bedienings- en veiligheidsinstructies (181 pagina's)
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Note: If you do not press any button for one
minute after the product has been switched on,
the product automatically switches off.
Start-up
This product can be used for detecting power lines.
Right after switched on the product, a selection
of menu points will appears at the bottom of the
display
:
2
(Fig. A)
The selection arrow ( ▼ )
is over the menu
16
point for Wooden beam search (STUD)
,
20
when the product is switched on for first time
right after inserting battery. For subsequent power
on, the selection arrow will be pointing over the
last selected menu. Bring the selection arrow over
the desired menu point by repeatedly pressing the
►
selection button (
)
. The meaning of the in-
4
dividual menu points are:
: Wooden beam search
: Metal search
: Void search
: Power line search
Guide the detector over a location on the surface
to be examined, where you know that there is
no object, which you are looking for. Then press
the PUSH button
and keep it pressed down.
6
A tick symbol
will be flashing on the right
15
side top corner of the display
to indicate the
2
calibration is on going. Wait for a while for the
calibration process to complete. The completion
of the calibration will be indicated by a short
double signal tone and the tick symbol
on
15
the display
will stop flashing. While keeping
2
the PUSH button
pressed, guide the detector
6
over the surface to be examined. It is possible
that during this some short signal tones may
14 GB/IE/NI
Hoofdstukken
Inhoudsopgave
