Chain Saw Operates In-Battery Discharged Termittently; Maintenance, Cleaning And Transport - Bosch Gke 18V-40 Oorspronkelijke Gebruiksaanwijzing
Inhoudsopgave
Beschikbare talen
Beschikbare talen
32 | English
Problem
Possible Cause
Power tool defective
Chain saw operates in-
Battery discharged
termittently
Power tool defective
Saw chain dry
No oil in reservoir
Oil outlet (6) clogged
Oil filter clogged
Saw chain/guide bar
No oil in reservoir
hot
Chain tension too high
Dull saw chain
Oil passage clogged
Chain saw rips, vi-
Saw chain tension too loose
brates, does not saw
Dull saw chain
properly
Saw chain worn out
Saw chain teeth are facing in the wrong direction Reassemble with saw chain in correct direction
Chain bar damaged or worn
Excessive vibrations/
Power tool defective
noise
Incorrect chain assembly
Sawing time per bat-
Too much friction, due to lack of lubricant
tery charge too low
Saw chain needs cleaning
Poor sawing technique
Battery not fully charged
Battery out of the allowable temperature range
Chain tension too high
Dull saw chain
The saw chain is run-
Battery discharged
ning slow
Battery out of the allowable temperature range
Battery is too hot
Maintenance and Service
Maintenance, cleaning and transport
Warning! Switch off and remove battery from power
u
tool before adjusting or cleaning.
Always wear suitable clothing and personal protective
u
equipment.
Regularly check the chain saw for obvious defects
u
such as loose, dislodged or damaged saw chain and
chain bar, loose fixings and worn or damaged compon-
ents.
F 016 L94 910 | (13.12.2024)
Corrective Measure
Contact Service Agent.
Recharge battery; also see "Battery Charging"
Contact Service Agent.
Refill oil, see "Saw chain lubrication"
Clean oil outlet (6)
Clean oil filter / contact customer service
Refill oil
Tension saw chain.
Replace saw chain
Contact Service Agent.
Adjust chain tension
Replace saw chain
Replace saw chain
Replace chain bar or contact Bosch Service
Centre
Contact Service Agent.
Check whether the chain is correctly assembled,
see "Mounting the chain bar and tensioning the
saw chain".
Ensure chain lubrication (see "Saw chain lubrica-
tion")
Clean saw chain
see "Working with the chain saw"
Recharge battery; also see "Battery Charging"
Allow battery to warm naturally to room temperat-
ure (within battery operating temperature 0–
45 °C)
Tension saw chain.
Replace saw chain
Recharge battery; also see "Battery Charging"
Allow battery to warm naturally to room temperat-
ure (within battery operating temperature 0–
45 °C)
Allow to cool
Do not modify this product. Unauthorized modifications
u
may impair the safety of your product and may result in
increased noise and vibration and invalidates warranty.
Maintenance and cleaning
– For safe and proper working, always keep the power tool
and its ventilation slots clean.
– Do not use water, solvents or polishes to clean the power
tool.
– Use a clean cloth or stiff brush to carefully remove any
debris from the power tool.
– Use a clean cloth to carefully remove debris from the oil
outlet (6). Make sure that no debris enters the oil outlet
Bosch Power Tools
Inhoudsopgave
