TechniSat VIOLA 2 Handleiding pagina 19
4.4 General device functions
4.4.1 Switching on the device
>
In order to guarantee good DAB+/FM reception, please fully extend the antenna
located on the rear of the device. To do so, please refer to Section 4.3.3.
>
First prepare the Viola 2 for operation as described in Section 4.3.1 and 4.3.2.
>
Switch on the Viola 2 by pressing the On/Off button.
After switching on for the first time, the device automatically performs a
complete scan in DAB mode. While scanning, the display information shows
the progress, as well as the number of digital radio stations detected. After
completing the station scan the first DAB+ channel is played.
36
BDA_Viola_2.indd 36-37
4.4.2 Switching off the device
With mains operation:
>
By briefly pressing the On/Off button you can switch the device to standby
mode. [Standby] appears briefly on the display. The date and time are shown on
the display. The display brightness in standby mode can be adjusted by following
the instructions in Section 8.2.
With battery operation:
>
With battery operation the device is switched to enhanced standby mode by
pressing the On/Off button. In this case, there is no date and time display.
4.4.3 Adjusting the volume
>
Adjust the volume using the Vol +/- knob. The set volume is shown on the
display by way of a bar chart. Also refer to Section 4.3.4 for operation when
headphones are connected. To increase the volume, turn the knob to the right; to
lower it, turn to the left.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
37
16/05/2018 13:41
