Inventum IOM6035GT Handleiding pagina 25
Inbouwoven multifunctioneel
Beschikbare talen
Beschikbare talen
Component
Function button
Quick pre-heat button
Timer button
Child lock button
Standby button
Note:
You can use the up/down button or slider button to change the appliance settings.All three buttons have the
same function.
3
installation
SAFETY INSTRUCTIONS FOR INSTALLATION
• Safety during use can only be guaranteed when installation has been performed correctly and in accordance with
instructions. The installer is liable for damage caused by incorrect installation.
• Have the electrical installation performed by a qualified electrician. The electrician must comply with national and
local regulations.
• The appliance falls under protection class I and may only be used in combination with an earthed connection.
• Connect the appliance in accordance with the installation instruction to a fixed installation with in-built switch-off
provisions.
• During installation make sure the power cord does not get crushed and does not run along sharp edges. Place the power
cord in such a way that it does not make contact with hot components of the appliance.
• The connection point, socket and/or plug must always be accessible.
• The kitchen furniture in which the appliance will be installed should at least be resistant to a temperature of 90°C.
This also applies to the doors and fronts of the furniture.
• Check that the kitchen furniture in which the appliance will be installed is firmly fastened, e.g. by fastening the furniture
to adjacent elements.
• In case of incorrect installation or connection, the warranty becomes void.
• Changes to the appliance, replacement of the power cord included, should be performed by a certified installer.
• Ensure sufficient ventilation and fresh air around the appliance.
REMOVING THE PACKAGING
1. Remove the packaging.
Careful:
Remove the stickers from the door.
2. Check the appliance for damage.
3. Check that the voltage corresponds with that on the type plate.
PREPARATION FOR INSTALLATION (Figure 3)
(*) The minimum dimension for B1 is 585 mm and the maximum dimension is 595 mm.
Note:
Ensure the kitchen furniture is prepared for the dimensions of the appliance.
INSTALLING THE APPLIANCE
Pre-requirements.
• Ensure the kitchen furniture is prepared in accordance with the correct dimensions.
Warning:
Installing the appliance requires two persons.
Careful:
During installation make sure the power cord does not get crushed and is not placed on top of the appliance.
Function
Selecting a function.
Selecting the quick pre-heat function.
Using the timer function
Switching the child lock on/off
Cancel a function or program and return to stand-by mode.
25
English
•
