Roborock Saros Z70 Gebruiksaanwijzing pagina 12
Beschikbare talen
Beschikbare talen
Deactivating WiFi
To disconnect the robot from WiFi, press
the Reset button until you hear a voice
message. Then wait for 5 minutes and the
WiFi will be automatically deactivated. If you
want to reconnect, please follow the related
connecting instructions.
Restoring Factory Settings
If the robot does not function properly after
a system reset, power it on. Press and hold
and at the same time, press the Reset button
until you hear the "Restoring factory settings.
This will take about 5 minutes." voice
message. The robot will then be restored to
factory settings.
Routine Maintenance
D
Notes:
• The dock must be unplugged and the robot must
be turned off with its robotic arm retracted in its
compartment before cleaning or maintaining the dock
and robot.
• The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Main Brush
D1
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brush
D1-4—Slots
D1-5—
Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-6—
Lift the main brush and pull it out,
remove any entangled hair or dirt at
both ends of the main brush.
D1-7—
Reinstall the main brush.
D1-8—
Reinstall the main brush cover. Make
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a
click.
Notes:
• It is recommended to wipe the main brush with a wet
cloth. If the main brush is wet, air-dry it away from
direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brush.
Side Brush
D2
* Clean monthly and replace every 3-6 months.
Unscrew the side brush screw. Remove and
clean the side brush. Then, align the central
groove with the raised position on the robot
and tighten the screw to reinstall the side
brush.
Omnidirectional Wheel
D3
* Clean as required.
D3-1—
Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note:
The omnidirectional wheel bracket cannot be
removed.
D3-2—
Rinse the wheel and the axle with
water to remove any hair and dirt.
012
Air-dry, reinstall, and press the wheel
and axle back in place.
Main Wheels
D4
* Clean as required.
Clean the main wheels with a soft, dry cloth.
Dustbin
D5
* Clean as required.
D5-1—
Remove the magnetic top cover of
the robot and press the dustbin
latch to take out the dustbin.
D5-2—
Remove the dustbin lid, press the
filter latch to remove the washable
filter, and then empty the dustbin.
D5-3—
Fill the dustbin with clean water,
and reinstall the washable filter and
dustbin lid. Gently shake the dustbin,
and then pour out the dirty water.
Note:
To prevent blockage, only use clean water without
any cleaning liquid.
D5-4—
Allow at least 24 hours for the
dustbin, dustbin lid and the filter to
dry thoroughly before reinstalling
them.
Washable Filter
D6
* Clean every 2 weeks and replace every 6-12 months.
D6-1—
Remove the dustbin lid and the
washable filter.
D6-2—
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note:
Do not touch the surface of the filter with hands,
brushes, or sharp objects to avoid potential damage.
