Roborock Saros Z70 Gebruiksaanwijzing pagina 13
Beschikbare talen
Beschikbare talen
D6-3—Allow at least 24 hours for the filter to
dry thoroughly before reinstalling it.
Mop Cloths
D7
* Clean as required and replace every 1-3 months.
D7-1—
Remove the mop cloths from mop
cloth mounts. Clean the mop cloths
and air-dry them.
Note:
A dirty mop cloth will affect the mopping
performance. Clean it before use.
D7-2—
Stick the mop cloths on the mounts
flat in place.
Robot Sensors
D8
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Upper Surface Sensor
D8-2—Front Navigation Sensor
D8-3—Wall Sensor
D8-4—Communication Sensor
D8-5—Rear Navigation Sensor
D8-6—Cliff Sensors
D8-7—Carpet Sensor
Moving the Dock
D9
To move the dock, grip the power cord
storage slot on the back with one hand
and the inner side of the front board with
the other hand. Do not lift the dock base,
water tank handles, or dust container cover
directly to prevent the dock from falling off.
Dirty Water Tank
D10
* Clean as required.
Open the dirty water tank lid and pour
out the dirty water. Fill the tank with clean
water, close the lid, lock the latch, and
shake. Pour out the dirty water. Lock the lid
and reinstall the tank.
Notes:
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
Charging Contacts
D11
* Clean as required.
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
Replacing Disposable Dust Bag
D12
* Replace as required.
D12-1—
Remove the dust container cover.
Note:
To prevent the dust container cover from falling
and hitting the robot, remove the cover with both
hands, one on each side.
D12-2—
Remove the disposable dust bag
and discard it.
Notes:
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before putting back the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
Clean the filter with a dry cloth,
D12-3—
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
013
Note:
Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the
dock.
D12-4—
Reinstall the dust container cover
in place to make sure the dust
container is securely sealed.
Cleaning Tray Module
D13
* Clean as required.
D13-1—
Remove the cleaning tray module.
D13-2—
Remove the cleaning tray and filter
from the module and then rinse
them with water.
D13-3—
Reinstall the filter and cleaning tray.
Then, reinstall the cleaning tray
module.
