Roborock Saros Z70 Gebruiksaanwijzing pagina 8
Beschikbare talen
Beschikbare talen
Dustbin
A4
A4-1—Filter Latch
A4-2—Suction Inlet
A4-3—Dustbin Lid
A4-4—Washable Filter
A4-5—Dustbin Latch
A4-6—Air Inlet
Mop Cloth Mount
A5
A5-1—Hook and Loop Pads
A5-2—Mop Axle
Note:
Secure the mop cloths flat in place.
Mop Cloth
A6
Dock Base
A7
Power Cord
A8
Disposable Dust Bag
A9
Empty Wash Fill Dock
A10
A10-1—Water Tank Handle
A10-2—Dirty Water Tank
A10-3—Filter
A10-4—Cleaning Solution Cartridge
A10-5—Dock Base
A10-6—Clean Water Tank
A10-7—Water Tank Latch
A10-8—Status Indicator Light
• Breathing: Emptying/Mop washing
• Red: Dock error
• Off: Powered off/Charging
A10-9—Dust Bag Slot
A10-10—Dust Container Cover
A10-11—Charging Contacts
A10-12—Drain Port
A10-13—Cleaning Tray Filter
A10-14—Drying Air Outlets
A10-15—Dock Location Beacon
A10-16—Suction Inlet
A10-17—Robot Refill Port
A10-18—Cleaning Tray Module
A10-19—Water Level Float
A10-20—Clean Water Dispensers
Empty Wash Fill Dock (Back
A11
View)
A11-1—Power Port
A11-2—Power Cord Storage Slot
A11-3—Cord Outlets
Installation
B
Important Information
B1
B1-1— Remove cords, hard or sharp
objects (such as nails and glass),
and loose items from the floor. Also,
relocate unstable, fragile, valuable,
or hazardous items (such as balls,
scissors, knives, electrical appliances,
medicines, toxic substances, glass,
porcelain, liquid-filled containers,
and lit candles) to prevent injury
or damage due to items becoming
tangled in, struck by, dragged,
knocked over, picked up, or dropped
upon pickup by the robot.
008
B1-2—
When using the robot in a raised
area (such as in a duplex apartment),
always use a physical security
barrier to prevent personal injury
or property damage caused by
accidental falls of the robot or the
object picked up by the robotic arm.
Notes:
• When using the robot for the first time, follow it
throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
• To prevent excessive buildup of dirt on the mop cloths,
floors should be vacuumed at least three times before
the first mopping cycle.
Assembly
B2
B2-1—Attach the dock base by pressing
down both sides of the base and the
connecting part in the middle firmly
until you hear a click.
Note:
When moving the dock, secure the water tanks to
prevent them from falling off.
B2-2—
Connect the power cord to the back
of the dock, and the power cord can
exit at either the left or right cord
slot opening.
B2-3—
Align and install the mop axles into
the robot in place until you hear a
click.
Positioning the Dock
B3
Place the dock on a hard, flat floor (wood/
tile/concrete etc.), flat against a wall, and
reserve a space of at least 0.75 m (2.46 ft)
