Sharp UD-T10A Gebruikershandleiding pagina 6
Beschikbare talen
Beschikbare talen
6
Operating environment
• Working temperature: 5 °C to 35 °C.
• This machine is suitable for indoors, e.g. Living room, study, offi ce room,
warehouse, basement, underground garage.
• Make sure the door and window are closed before turning on the unit to
get the best result.
• Ensure that the unit is placed on a stable and fl at fl oor surface. If the
fl oor's surface is not even, there is a risk that the unit may be unstable
and topple over. Also excessive vibration and noise may be result.
Components diagrams – parts names
Refer to the
2 and
3 on page 2 for the location of the following parts:
1. Handle
2. Control panel
3. Louver (air outlet)
4. Top cover
5. Front cover
6. Air intake and dust fi lter
7. Drain pipe outlet
8. Mains lead
9. Side cover
10. Water tank
Control panel
Refer to the
4
of the control panel on page 2.
1. WATER FULL – Lights up when the water tank is full.
2. DEFROST INDICATOR – Lights up when the unit is in the defrost
mode.
3. HUMIDITY LEVEL – shows the level of humidly set.
4. HUMIDITY – Press this button to set the desired humidity.
5. TIMER Off INDICATOR – When the timer is active, this indicator lights
up.
6. TIMER – Press this button to set the machine shutdown time. The
display will show the shutdown time accordingly.
7. ON/OFF INDICATOR – Lights up when the unit is on, turns off when
unit is off .
8. ON/OFF – Press this button to switch the power on and off .
Note: When a button is pressed, a bleep will be heard.
Operating introduction
Power on
Plug in the appliance to the mains supply and press the ON/OFF button, it
will start and it will start to operate.
When powered on, the unit will start to dehumidify. The compressor will
activate after fi ve minutes.
If the appliance is turned off via the ON/OFF switch and not unplugged
from the mains supply, it will start up again in the same mode.
Power off
While the appliance is operating, press the ON/OFF button to turn it off .
Humidity setting
To change the humidity level, press the HUMIDITY button, each
time the button is pressed, the display will change as follows
40%~50%~60%~CONT~40%. After setting the humidity level, the display
will revert to the current moisture level detected by the internal sensor.
When the ambient humidity is 2% lower than the set humidity, the
dehumidifying action will stop and the fan stops for 1 hour; the unit
will not detect the humidity during this period. After 1 hour, the fan will
start and work for 3 minutes during which time the ambient humidity is
detected. When the unit detects that the ambient humidity is 2% higher
than the set humidity, it will start dehumidifying and the fan returns to its
set speed.
When operating in the dry clothes function, the machine is running in
CONT status.
Timer
To start the timer function, press the TIMER button. Each time the button
is pressed, the timer will cycle 2H, 4H, 6H, off . For 2H, 4H and 6H the
respective light will illuminate.
Memory function
1. If the unit is turned off via the ON/OFF button, when turned back on
again it will resume from the function it was turned off in. Note that if
the timer was set or if the unit was in the lock mode, these settings are
not stored.
2. If the mains power is disconnected while the unit is operating, it will
restart automatically when it is reconnected. The unit will restart in the
mode/function it was operating in prior to the mains disconnection.
Water tank full auto-stop function
When the water tank is full, the unit will stop operation, the and the unit
will bleep to remind you to empty the water tank. To reset, remove the
water tank, empty and replace. When the empty water tank is put back into
the unit, it will restart. Note that the compressor will take about 5 minutes
to operate.
Auto defrost
If the unit is used in a low temperature environment, the internal
evaporator may be covered by frost. In order to make sure the machine
operates normally, the machine has auto-defrost function. Should
the internal sensor detect a temperature of ≤-1 °C the machine will
enter auto-defrost function. That means it will run continuously in the
dehumidifi cation mode for 30 minutes, then the machine will start the
defrost cycle, the DEFROST light will illuminate, the compressor will stop
and that fan will operate at high speed.
When temperature of evaporator is ≥2 °C and the unit has been in the
defrost mode for 10 minutes, the auto-defrost mode will turn off and the
compressor turns on. At this point the unit will start to dehumidify and the
DEFROST light will turn off .
While in the defrost mode and the temperature of the evaporator is ≥0 °C
for two minutes, the defrost function is cancelled.
Laundry mode
To enter the laundry mode, press the HUMIDITY button for 3 seconds.
When in laundry mode all 4 humidity indicator lights will illuminate.
While in the laundry mode, the fan will operate at 1000rpm and the
dehumidifi cation level is set to the continuous mode. After 6 hours in this
mode, the fan will continue to run but at a lower speed of 800rpm. This
ensures that the dehumidifi er runs more eff ectively once the clothes have
lost most of their moisture.
The laundry mode can be cancelled at any time by pressing the HUMIDITY
button for 3 seconds or by powering the unit off by the ON/OFF button.
